Kenmore Dryer Model 110.62824100 Parts

Kenmore Dryer Model 110.62824100 Parts
Brand:Kenmore
Model:110.62824100
Product:Dryer
Subtype:Electric

Featured parts for Kenmore Dryer

132 results
Go
Watch Video
$17.93

Dryer thermal fuse located on the blower housing. If the dryer overheats, the thermal fuse blows cutting off power to the motor or the heating system. When the fuse is bad the dryer won't start or will run but not heat. The thermal fuse cannot be reset. Fuses often blow due to a clogged dryer vent.

Watch Video
$22.40

Dryer drum drive belt. The belt is flat, 92-1/4 inches long, 1/4 inch wide and has 4 ribs and 3 grooves. It replaces many other belts, including some with 5 ribs and 4 grooves. If the drum does not turn, but you can hear the motor running then there is a good chance the belt has broken.

Watch Video
$58.52

Dryer heating element. If your dryer does not heat first check for a blown thermal fuse on the blower housing before replacing the heating element. In most cases the heating element will have a break in the element if defective. *May need wire connector to install heating element.

Watch Video
$39.95

Dryer heating element thermal cut-off (thermal fuse) 309 degrees and high limit thermostat 250 degrees, with wiring kit. If the dryer does not heat the thermal cut off may have blown and a new high limit thermostat is needed.

Watch Video
$28.24

Dryer door switch assembly. If the dryer does not start then the door switch could be defective. This switch also replaces the two wire switch.

Watch Video
$15.16
24% Off MSRP: $19.95

Rear drum support roller kit. This kit contains two drum support rollers. If the drum rollers are worn out, the dryer may not turn properly or may be excessively noisy. Be aware that the drum bearings are self-lubricating; it is not necessary to lubricate them yourself.

Watch Video
$18.92
11% Off MSRP: $21.26

Dryer cycling thermostat with internal bias heater, L155-25. If the dryer won't heat, it is unlikely that this thermostat is causing the issue, as the thermal fuse or thermal cut-out normally fail first.

Watch Video
$56.04

Repair kit for Whirlpool, Kenmore, Roper dryer; rollers, belt and idler pulley, for 29" wide Dryers built 1965 and later. This dryer maintenance kit contains all of the parts that are commonly defective when the dryer is noisy.
-Call with model# to verify if kit is compatible with your dryer.

Watch Video
$5.96
56% Off MSRP: $13.45

Dryer door catch kit. This kit includes three different door catches; you will need to select the door catch that fits your model.

Watch Video
$50.81

Dryer lint screen assembly. Proper air flow is critical to dryer operation so the filter should be cleaned before every load.

Watch Video
$20.51

Dryer belt tension idler pulley assembly.When the idler pulley goes bad it will usually make a high pitch squeeling or rattling noise.

Watch Video
$17.53

Dryer high-limit thermostat, L250-80, with terminal extension arm. This thermostat should be closed for continuity at room temperature and opens at around 250 degrees Fahrenheit. If the dryer won't heat, the high-limit thermostat might be defective.

Watch Video
$12.16

Dryer tri-ring retainer for drum support rollers.

Go
Related Articles & Videos
Common Problems
With most appliances and equipment there are only a handful of problems that crop up. Since 1912, we've learned to recognize the most common problems ― and their solutions. Do any of these look familiar?
Dryer won't start
8 possible causes and potential solutions
Dryer won't start
Dryer stopped spinning
7 possible causes and potential solutions
Dryer stopped spinning
Dryer drum not turning
7 possible causes and potential solutions
Dryer drum not turning