Dryer drum slide. There are two of these needed on your dryer. The dryer's drum slides help to support the front of the drum as it rotates. If the drum slides are worn out, the dryer will be noisy. Because the slides wear out at the same rate, we recommend replacing all of the slides together.
Dryer drum drive belt, 89-1/2 inches long, 4 ribs. The drive belt is a very long, slender belt that wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.
Dryer drum seal for the lower front. If the seal is worn the drum glides are likely worn and may need to be replaced. See related items below.
Front drum bearing kit
Dryer lint filter. Keeping the filter clean is vital to dryer operation.
Dryer idler pulley wheel. If the pulley wheel is worn down, it may cause the dryer to be excessively noisy.
Rear drum bearing kit. *Bearing plate has slot in it for ground strap. The drum bearing supports the rear of the dryer drum. Over time, the drum bearing wears out. If the drum bearing is worn out, the dryer may make noise.
Dryer drum rear bearing sleeve.
Dryer timer knob assembly in white with chrome accent ring and black indicator. The knob has a D shaped shaft and is 2-3/4 inches in diameter.
Front bulkhead assembly with moisture sensor bars.
Dryer rotary start switch. If the start switch is defective, the dryer won't start. To determine if the start switch is defective, use a multimeter to test it for continuity.
Light bulb, 120V, 10W
All purpose switch
Handle, white. Snaps in place