Refrigerator icemaker. This item does not include a new shut off arm. To remove the existing shut off arm from the old icemaker, lift it to the up position, unhook it from the fill cup bearing, and pull it out of the module.
White touch-up paint. .6 oz.
2 Terminal door switch
Refrigerator crisper pan
Refrigerator defrost timer kit. This timer is designed for continuous or cumulative run defrost systems. Turn the dial on the timer clockwise to advance it into and out of defrost.
Compressor run capacitor
Spray paint, white, 12 ounces
Refrigerator shelf retainer bar end cap, thin bar
Refrigerator icemaker water inlet valve. If the icemaker is making small or hollow cubes then the water inlet valve may be restricted and require replacement.
Black appliance touch-up paint.
Universal in-line water filter designed to improve the taste of drinking water and the clarity of ice cubes by reducing contaminants such as lead and chlorine. Push-in fittings can be used in both copper or plastic 1/4 inch water lines. Replace filter every 6 months for optimal performance.
Refrigerator icemaker control module and motor assembly. Located under the white cover of icemaker and controls ice ejector bar, heater and water inlet valve for the icemaker. If the icemaker is not making ice or making too much ice the model may be defective.
Refrigerator defrost thermostat, clip-on. This defrost heater monitors the temperature of the evaporator coils and sends power to the defrost heater during the defrost cycle. If your defrost thermostat is defective, the refrigerator will not defrost.
Refrigerator evaporator fan motor. The evaporator fan motor draws air over the evaporator (cooling) coils and circulates the cold air through the refrigerator and freezer compartments.
Refrigerator defrost drain strap kit to prevent the drain tube from freezing