Dryer drum belt, length 88.75" x width 1/4". If the drum does not turn, but you can hear the motor running then there is a good chance the belt has broken.
Dryer rear drum bearing kit. The holes in the metal plate are not threaded. Use the self tapping screws in the kit to thread the plate. If the dryer is noisy then the rear bearing could be worn and require replacement.
Dryer door catch kit. If the dryer does not latch properly then either the strike or catch is likely damaged and will need to be replaced.
Dryer lint trap. Proper air flow is critical to dryer operation so the filter should be cleaned before every load. Replace the filter if it has any tears or rips in it.
Dryer gas valve solenoid coil kit. The kit includes both 2 and 3 wire coils. If the dryer does not heat or heats intermittently the gas valve coils may be defective.
Washing machine drain pump. On some models you will need to configure the replacement pump to match the old pumps outlet port direction and reuse the old mounting bracket. If the washer does not drain then the drain pump may be clogged, damaged, or defective.
Washer drive belt. If this belt is broken, the washer will not spin or agitate.
Dryer drum glide. These drum glides help to support the front of the dryer drum as it rotates. Sold individually. It is recommended to replace both at one time.
Rear bearing support cup for dryer drum. If the drum support ball is also worn you can purchase these items in a drum bearing kit. See related item.
Idler pulley and arm, dryer
Front lower felt seal. Comes with high temp adhesive for installation.
Knob, dryer timer, white
Drive Motor for Dryer Drum and Blower With Pulley
Dryer blower wheel. If the blower wheel is noisy the center hole may be stripped out or the fins may be damaged from debris getting through the lint filter.