Washer door strike. If the washing machine won't start, inpsect the actuator for damage. If the actuator is damaged the door will not latch properly and the washer will not turn on.
Door lock & switch assembly
Washing machine drain pump. On some models you will need to configure the replacement pump to match the old pumps outlet port direction and reuse the old mounting bracket. If the washer does not drain then the drain pump may be clogged, damaged, or defective.
Washing machine door hinge.
Washing machine door boot. If the washer is leaking, the door boot may have a tear in it. Overloading the washer is the most common cause for a torn door boot.
Shock absorber mounting pin
Washing machine shock absorber kit. The shock absorbers dampen the vibration of the washer tub. If one or more of the shock absorbers are worn out, the washer will vibrate or shake.
Retaining ring with spring for boot seal.
Washer water inlet valve with thermistor. If the washer fills slowly or does not fill at all, then the water valve may be restricted and require replacement.
Universal washing machine water supply hose set. Includes 2 extra strong 6 foot braided stainless steel hoses with hose washers already installed. It is recommended to replace washing machine inlet hoses after 5 years of use to reduce the risk of hose failure.
Washer motor control board. This part contains the board, bracket, tape and screw mounted on control. NOTE: This part is often misdiagnosed. Please enter your appliance model# into our Repair Help section for additional repair help.
Drain hose 98" long
Drive belt, front load washer