Dryer drum slide. There are two of these needed on your dryer. These go on the inner most slots on the front bearing. Sold individually will need to purchase two*. The drum slides support the front of the dryer drum instead of rollers or bearings. As they wear out the dryer will make more noise.
Dryer drum slide. There are two of these needed on your dryer. The dryer's drum slides help to support the front of the drum as it rotates. If the drum slides are worn out, the dryer will be noisy. Because the slides wear out at the same rate, we recommend replacing all of the slides together.
Dryer drum drive belt, 89-1/2 inches long, 4 ribs. The drive belt is a very long, slender belt that wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.
Dryer drum seal for the lower front. If the seal is worn the drum glides are likely worn and may need to be replaced. See related items below.
Light bulb, 120V, 10W
Rear drum bearing kit. *Bearing plate has slot in it for ground strap. The drum bearing supports the rear of the dryer drum. Over time, the drum bearing wears out. If the drum bearing is worn out, the dryer may make noise.
Dryer idler pulley wheel. If the pulley wheel is worn down, it may cause the dryer to be excessively noisy.
Dryer drum rear bearing sleeve.
All purpose switch
Dryer door catch kit
Dryer door strike.
Dryer top bearing retainer for dryer drum. If the dryer is noisy then this glide retainer and the glides are probably worn.
High-limit thermostat for dryer. L315-65. If the dryer overheats, this high-limit thermostat will cut off the power to the heating element. If the high-limit thermostat has blown, the dryer won't heat.
Inlet control thermistor.Resistence reading should be around 100K ohms at room temperature and decrease with temperature rise.