Dryer drum belt, length 88.75" x width 1/4". If the drum does not turn, but you can hear the motor running then there is a good chance the belt has broken.
Dryer door catch kit. If the dryer does not latch properly then either the strike or catch is likely damaged and will need to be replaced.
Dryer gas valve solenoid coil kit. The kit includes both 2 and 3 wire coils. If the dryer does not heat or heats intermittently the gas valve coils may be defective.
Dryer thermal limiter (or thermal fuse). May be located on the blower housing or element. If the dryer overheats, the thermal fuse blows to cut off power to the dryer. If the thermal fuse has blown, the dryer won't start. The thermal fuse cannot be reset--if the fuse has blown, it must be replaced
Washer drive belt. If this belt is broken, the washer will not spin or agitate.
Dryer lint trap. Proper air flow is critical to dryer operation so the filter should be cleaned before every load. Replace the filter if it has any tears or rips in it.
Washing machine drain pump. On some models you will need to configure the replacement pump to match the old pumps outlet port direction and reuse the old mounting bracket. If the washer does not drain then the drain pump may be clogged, damaged, or defective.
Dryer drum glide. These drum glides help to support the front of the dryer drum as it rotates. Sold individually. It is recommended to replace both at one time.
Rear bearing support cup for dryer drum. If the drum support ball is also worn you can purchase these items in a drum bearing kit. See related item.
Front lower felt seal. Comes with high temp adhesive for installation.
Idler pulley and arm, dryer
Dryer blower wheel. If the blower wheel is noisy the center hole may be stripped out or the fins may be damaged from debris getting through the lint filter.
Washing machine main tub seal assembly. If the washer leaks then the tub seal may be bad.
Knob, dryer timer, white