Ignition System Tester
This part is used to test the spark on ignition coils. One of the first steps you should take when you are having ignition troubles is to test the ignition coil with this tool. This part can be used on all engines except the Vanguard 3 L/C gas engine.
Make changing your spark plug easier with a combination spark plug wrench. This part is used to make removing 13/16" and 3/4" hex head spark plugs much easier.
Small Flywheel puller with bolt spacing of 1 & 5/8". See related items for other sizes.
Starter clutch wrench.
This wrench is to be used with a 7/8 inch socket to install, remove, or torque starter clutches both quickly and easily.
Valve spring compressor
Piston ring compressor
For engines 5 HP and below
Carburetor jet removal screwdriver
Screwdriver-Carburetor Jet Removal
Tachometer (Treysit Sirometer)
This part is used to determine the RPMs of your engine. It measures from 800 to 25,000 revolutions per minute and can work on any small engine.
Torqux Star Bit set. T-10, T-15, T-20, T-25, T-27, T-30, T-40, T-45
Valve Lapping Tool also referred to as a valve grinding tool. Lapping compound is used on the valve face and the tool is used to turn the valve back and forth to form a good sealing surface.
This part measures the RPM of your engine. The meter will display the RPMs while the engine is running, when the engne is stopped, it will display the elasped time. The maximum speed this part measures is 20,000 RPMS and it updates every 1-2 seconds.
DC Shunt (Electrical)
Piston Ring Compressor
For engines above 5 HP