Dryer drum drive belt. The belt is flat, 92-1/4 inches long, 1/4 inch wide and has 4 ribs and 3 grooves. It replaces many other belts, including some with 5 ribs and 4 grooves. If the drum does not turn, but you can hear the motor running then there is a good chance the belt has broken.
Snap retaining ring. Used to keep rollers and idler wheels in place
Dryer thermal fuse and high limit thermostat kit for both gas and electric models. If the dryer does not heat then the thermal fuse may have blown and will need to be replaced.
Dryer lint filter (lint trap). Your lint filter should be replaced if it is torn or damaged in any way.
Screw, 10-24 3/8
Door catch kit, includes catch and clip (metal) Replace both parts for best results
Heating element assembly with replacement high limit thermostat, L248-80 (240 Volt, 4750 Watt). Dryer Heating element. If the dryer does not heat check for a blown thermal fuse or thermal cut out. Heating elements will often have a break in the coil element if defective.
Screw & Washer
Drum glide kit, right side. *Pad has adhesive backing
Blower wheel clamp
Belt idler rod and wheel assembly
Blower wheel, 3-1/8” deep, 8” fin diameter, 7-1/8” hub diameter, 20 standard fins, ½” diameter motor shaft, 7/16” motor shaft diameter to flat side of shaft. *If more than one blower wheel listed with your model please call with model and serial number to verify correct part.
Motor retaining clamp