Dryer drum roller assembly. Includes the roller shaft and mounting clips. As the bearing in the roller wears, it self-lubricates so no grease is needed. If the dryer is noisy then one or more of the rollers may be worn. The rollers should be replaced in sets either both front or both rear.
Dryer lint filter. The design of this part has changed. In order for it to install properly, you will need the related items.
Dryer drum drive belt. 1/4 inch wide with 4 ribs and 3 grooves. The drive belt is a very long, slender belt that wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.
Dryer moisture sensor bar. If the dryer timer does not advance properly inspect the moisture sensor bars for damage which can cause the automatic drying cycle to not work properly.
Lint filter cover *manufacture has modified the part and suggests replacing the filter guide also
Dryer thermistor assembly with wire harness. If the thermistor is defective, it can prolong or shorten the drying time or cause a fault code. A defective thermistor is not responsible for a dryer not heating.
Dryer idler pulley and spring kit for drum drive belt
Dryer high limit thermostat assembly. The thermostat has reset button in center it is trips due to poor air flow such as a clogged exhaust vent.
Gas dryer igniter with bracket and wire harness. This is a round spiral-style igniter. The igniter uses heat to ignite the gas in the burner assembly. If the igniter is defective, the gas will not ignite and the dryer will not heat.
Side or bottom venting kit for LG dryers. Be aware gas models cannot vent to the right.
Felt seal, dryer drum
Conversion kit, Natural to LP (liquid propane) gas