Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.
Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.
Dryer felt pad for drum glide. Fits under drum glide, peel and stick
Idler pulley wheel and bearing assembly. The idler pulley puts tension on the drive belt. If the idler pulley fails to put the proper amount of tension on the belt, the dryer will not spin.
Three terminal door switch kit. Be aware that this switch replaces older 2 terminal switches.
Igniter (Bracket is no longer included.) If your old igniter was round you will need to order the bracket in the related parts below.
Drum support roller
Cylinder felt seal. For adhesive see required parts below
Dryer drum drive belt
Washer. Has a 3/4-inch outside diameter.
Retainer snap ring. Used to hold drum rollers and idler pulleys in place.
Door catch kit, includes catch and clip (metal) Replace both parts for best results
Dryer drum glide
Front cover top retaining spring clip