Dryer drum belt, length 88.75" x width 1/4". If the drum does not turn, but you can hear the motor running then there is a good chance the belt has broken.
Dryer rear drum bearing kit. The holes in the metal plate are not threaded. Use the self tapping screws in the kit to thread the plate. If the dryer is noisy then the rear bearing could be worn and require replacement.
Dryer door catch kit. If the dryer does not latch properly then either the strike or catch is likely damaged and will need to be replaced.
Dryer lint trap. Proper air flow is critical to dryer operation so the filter should be cleaned before every load. Replace the filter if it has any tears or rips in it.
Washer drive belt. If this belt is broken, the washer will not spin or agitate.
Dryer gas valve solenoid coil kit. The kit includes both 2 and 3 wire coils. If the dryer does not heat or heats intermittently the gas valve coils may be defective.
Front upper felt glide pad. Includes nylon glides, adhesive, and installation instructions. These drum glides help to support the front of the dryer drum as it rotates.
Rear bearing support cup for dryer drum. If the drum support ball is also worn you can purchase these items in a drum bearing kit. See related item.
Idler pulley and arm, dryer
Dryer blower wheel. If the blower wheel is noisy the center hole may be stripped out or the fins may be damaged from debris getting through the lint filter.
Glide n Guard floor protectors.Are you moving? Do you need to clean behind your appliance?. These are made from polymer plastics that allow anyone to easily glide appliances for maintenance, cleaning, or relocating. Set of six connecting pads. 25-1/2 by 3-3/4 inches each.
Control knob
Lower felt seal, dryer drum front. See related parts for hi temp adhesive
Water inlet valve. The water inlet valve opens to allow hot, cold or warm water to enter the washing machine. If the water inlet valve is defective, the washer may fill slowly or not fill at all.