Price Match GuaranteeMaytag Dryer GDG7600 Parts
Shop replacement repair parts for Maytag Dryer model GDG7600
Dryer drum support roller kit. Includes two washers. When the drum rollers are worn out, they can cause the dryer to make a loud rumbling noise. Both rollers should be replaced at the same time. The roller does not need lubrication, the bearing is self-lubricating.
Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.
RC Item #2893
The Whirlpool Dryer Cycling Thermostat WP3387134, rated at L155-25, regulates the temperature within your dryer. Signs that the thermostat needs replacement include inconsistent drying temperatures or the dryer running excessively hot. The WP3387134 is compatible with various dryer models.
Dryer drum drive belt, 100 inches long, 3/8" wide,5 ribs 4 grooves. The drive belt wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.
Snap retaining ring
Dryer blower wheel for exhaust with clamp. If the dryer does not heat properly then this wheel may be stripped causing an air flow problem.
High temperature adhesive for installing rubber feet and felt seals, 2 ounces.
Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.
Dryer drum bearing slide kit
Self-tapping screw.
Dryer igniter with wire harness connecter. This is a flat-style igniter. The igniter uses heat to ignite the gas in the burner assembly. If the igniter is defective, the gas will not ignite and the dryer will not heat.
Dryer idley pulley. The idler pulley puts tension on the drive belt. If the idler pulley fails to put the proper amount of tension on the belt, the dryer will not spin.
Screw, 10-24 3/8
Three terminal door switch kit. Be aware that this switch replaces older 2 terminal switches.
Dryer door latch & catch kit
Frequently Purchased Together For This Model
Family-owned and operated since 1912, Burke America Parts Group is the longest-running genuine appliance, HVAC, and outdoor power equipment parts solution in North America. At Repair Clinic, we're proud to be an international brand trusted by the pros as well as the DIY community.
About Repair Clinic