Dryer drum belt, length 88.75" x width 1/4". If the drum does not turn, but you can hear the motor running then there is a good chance the belt has broken.
Dryer rear drum bearing kit. The holes in the metal plate are not threaded. Use the self tapping screws in the kit to thread the plate. If the dryer is noisy then the rear bearing could be worn and require replacement.
Dryer door catch kit. If the dryer does not latch properly then either the strike or catch is likely damaged and will need to be replaced.
Dryer lint trap. Proper air flow is critical to dryer operation so the filter should be cleaned before every load. Replace the filter if it has any tears or rips in it.
Washer drive belt. If this belt is broken, the washer will not spin or agitate.
Dryer thermal limiter (or thermal fuse). May be located on the blower housing or element. If the dryer overheats, the thermal fuse blows to cut off power to the dryer. If the thermal fuse has blown, the dryer won't start. The thermal fuse cannot be reset--if the fuse has blown, it must be replaced
Dryer heating element and housing assembly. If the dryer does not heat check for a blown themal fuse or thermal cut out. Heating elements will often have a break in the coil element if defective.
Rear bearing support cup for dryer drum. If the drum support ball is also worn you can purchase these items in a drum bearing kit. See related item.
Dryer high-limit thermostat, L260-70F. If the dryer overheats, this high-limit thermostat will cut off the power to the heating element. If the high-limit thermostat has blown, the dryer won't heat.
Idler pulley and arm, dryer
Front upper felt glide pad. Includes nylon glides, adhesive, and installation instructions. These drum glides help to support the front of the dryer drum as it rotates.
Glide n Guard floor protectors.Are you moving? Do you need to clean behind your appliance?. These are made from polymer plastics that allow anyone to easily glide appliances for maintenance, cleaning, or relocating. Set of six connecting pads. 25-1/2 by 3-3/4 inches each.
Dryer blower wheel. If the blower wheel is noisy the center hole may be stripped out or the fins may be damaged from debris getting through the lint filter.
Washing machine main tub seal assembly. If the washer leaks then the tub seal may be bad.