Jenn Air Dryer Model JDE1000W Parts

Dryer drum drive belt. The belt is flat, 92-1/4 inches long, 1/4 inch wide and has 4 ribs and 3 grooves. It replaces many other belts, including some with 5 ribs and 4 grooves. If the drum does not turn, but you can hear the motor running then there is a good chance the belt has broken.

Snap retaining ring. Used to keep rollers and idler wheels in place

Dryer thermal fuse and high limit thermostat kit for both gas and electric models. If the dryer does not heat then the thermal fuse may have blown and will need to be replaced.

Self-tapping screw.

Dryer lint filter (lint trap). Your lint filter should be replaced if it is torn or damaged in any way.

Screw, 10-24 3/8

Dryer blower wheel, 3-1/8" deep, 8" in diameter, 7-1/8" hub diameter, 20 standard fins, ½" diameter motor shaft, 3/8" motor shaft diameter to flat side of shaft. If more than one blower wheel is listed with your model, call us with your model and serial number to verify the part.

Screw & Washer

Top screw

Heating element assembly with replacement high limit thermostat, L248-80 (240 Volt, 4750 Watt). Dryer Heating element. If the dryer does not heat check for a blown thermal fuse or thermal cut out. Heating elements will often have a break in the coil element if defective.

Door catch kit, includes catch and clip (metal) Replace both parts for best results

Motor retaining clamp

Dryer door seal. *Seal may come as one piece, hold at one end and pull apart to separate.

Screw, 10-16 X 1/2

Blower wheel clamp