Idler pulley wheel
Dryer door seal. *Seal may come as one piece, hold at one end and pull apart to separate.
Blower wheel, 3-1/8” deep, 8” fin diameter, 7-1/8” hub diameter, 20 standard fins, ½” diameter motor shaft, 7/16” motor shaft diameter to flat side of shaft. *If more than one blower wheel listed with your model please call with model and serial number to verify correct part.
Belt idler rod and wheel assembly
Control thermostat, L146-25F, 240 Volt internal heater
High limit thermostat, L248-80F
Drum seal assembly
25 watt light-bulb, small base twist-lock, 120V
Screw, 10-16 X 1/2
Front glide kit, (1) right (1) left glide (2) pads with adhesive backing. Instructions included.
Glide for main drum front support, left side
Tumbler glide pad with adhesive backing
Lint screen housing duct kit