Dryer drum belt, length 88.75" x width 1/4". If the drum does not turn, but you can hear the motor running then there is a good chance the belt has broken.
Dryer rear drum bearing kit. The holes in the metal plate are not threaded. Use the self tapping screws in the kit to thread the plate. If the dryer is noisy then the rear bearing could be worn and require replacement.
Dryer door catch kit. If the dryer does not latch properly then either the strike or catch is likely damaged and will need to be replaced.
Dryer thermal limiter (or thermal fuse). May be located on the blower housing or element. If the dryer overheats, the thermal fuse blows to cut off power to the dryer. If the thermal fuse has blown, the dryer won't start. The thermal fuse cannot be reset--if the fuse has blown, it must be replaced
Dryer heating element and housing assembly. If the dryer does not heat check for a blown themal fuse or thermal cut out. Heating elements will often have a break in the coil element if defective.
Front upper felt glide pad. Includes nylon glides, adhesive, and installation instructions. These drum glides help to support the front of the dryer drum as it rotates.
Rear bearing support cup for dryer drum. If the drum support ball is also worn you can purchase these items in a drum bearing kit. See related item.
Strike, dryer door
Glide n Guard floor protectors.Are you moving? Do you need to clean behind your appliance?. These are made from polymer plastics that allow anyone to easily glide appliances for maintenance, cleaning, or relocating. Set of six connecting pads. 25-1/2 by 3-3/4 inches each.
High temperature adhesive for installing rubber and felt seals
Dryer terminal block repair kit. For power cord connection.
Seal, blower housing
Cycling thermostat with bias heater, L140-10F