Admiral Washing Machine Model ATW4475XQ0 Parts

Washing machine agitator directional cogs. These parts are also referred to as "dog ears." 4 per package. If the upper section of the agitator isn't turning properly, then these cogs are likely worn and will require replacement.

Washer drive motor coupler. New style with metal sleeves for added strength. This version replaces all previous motor coupler styles and versions. For direct drive washing machines. Common symptom of failed coupler is washer will fill, not agitate or spin but will drain the water from the tub.

Washing machine clutch assembly with hardware. *Blue spring for regular, large, extra and super capacity washers, green for compact models. A worn clutch often causes a slower spin speed which leaves the clothes soaked after the cycle.

Washing machine suspension spring. If the suspension spring is broken, the washer will be off balance.

White touch-up paint. .6 oz.

Transmission (gearbox) for direct-drive washing machines. If the gears inside the transmission are worn out, the washer may not spin.

Washer agitator bolt with rubber gasket and thread sealant. Head is 7/16 inches in diameter.

Direct drive washer lid switch assembly, If the washing machine does not spin the lid switch may have failed.

Spanner nut wrench for many Whirlpool, Kenmore, General Electric & Maytag inner tub lock (spanner) nuts

Washing machine main tub seal

Water inlet valve and inlet assembly with thermistor for water temp sensing. The water inlet valve opens to allow water to enter the washing machine. If the water inlet valve is defective, the wash may fill slowly or not fill at all.

Package of two 5-foot-long Industrial Braid hoses with pre-installed washers and straight ends. It is recommended to replace washing machine inlet hoses after 5 years of use to reduce the risk of hose failure.

Washing machine tub suspension pads (package of 3). These pads help to absorb the movement of the washer tub. If a tub pad is worn, the washing machine will be unbalanced and will vibrate or shake during the spin cycle.

Residential Washer Hoses- Fits most major washer brands. • Provides hot & cold water to the washer • (2) 4 Ft. hoses for hot & cold water • (4) Built-in O-rings • Anti-leak crimp
It is recommended to replace washing machine inlet hoses after 5 years of use to reduce the risk of hose failure.

Adjustable leveling leg for washing machine. This leveling leg has a rubber foot. If the leveling leg is not adjusted properly, the washer will be off-balance and will vibrate or shake during operation.