Dryer thermal fuse located on the blower housing. If the dryer overheats, the thermal fuse blows cutting off power to the motor or the heating system. When the fuse is bad the dryer won't start or will run but not heat. The thermal fuse cannot be reset. Fuses often blow due to a clogged dryer vent.
Dryer Repair Kit, includes drum belt, 4 rollers and idler pulley, For 27" wide dryers built 1965 and later and Thin Twins. This dryer maintenance kit contains all of the parts that are commonly worn when the dryer is noisy.
Dryer idler pulley assembly. Includes bracket and attached pulley
Dryer drum support roller. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.
Dryer door switch assembly. If the dryer does not start then the door switch could be defective. This switch also replaces the two wire switch.
Dryer drum drive belt, 93 1/2 inches long, 4 ribs 3 grooves. The drive belt is a very long, slender belt that wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.
Dryer heating element assembly. If the dryer does not heat the thermal fuse should be checked before replacing the heating element. Normally, the element will have a break in the coil if defective.
Dryer door catch kit. This kit includes three different door catches; you will need to select the door catch that fits your model.
Dryer lint filter. Air flow is vital to proper dryer operation. The lint filter should be cleaned before every load and replaced if damaged.
Dryer moisture sensor bar. This moisture sensor monitors the clothing’s moisture level and sends a signal to the control board when the clothes are dry. If your moisture sensor is defective, the dryer may shut off too early or continue running for a while after the clothes are dry. Two required.
Dryer thermistor. This thermistor should read approximately 11.9K Ohms of resistance at 70 degrees Fahrenheit (21’ Celsius). If the thermistor is defective, it may prolong or shorten the drying time or cause a fault code. A defective thermistor is not responsible for a dryer not heating.
Dryer idler pulley. The idler pulley puts tension on the drive belt. If the idler pulley fails to put the proper amount of tension on the belt, the dryer will not spin.
White touch-up paint. .6 oz.
Dryer tri-ring retainer for drum support rollers.