Jenn Air Washer/Dryer Combo Model LSE2704W-8 Parts
Featured parts for Jenn Air Washer/Dryer Combo
Dryer drum support roller kit. Includes two washers. When the drum rollers are worn out, they can cause the dryer to make a loud rumbling noise. Both rollers should be replaced at the same time. The roller does not need lubrication, the bearing is self-lubricating.
Dryer drum drive belt, 100 inches long, 3/8" wide,5 ribs 4 grooves. The drive belt wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.
Dryer cycling thermostat with internal bias heater, L155-25. If the dryer won't heat, it is unlikely that this thermostat is causing the issue, as the thermal fuse or thermal cut-out normally fail first.
Dryer blower wheel for exhaust with clamp. If the dryer does not heat properly then this wheel may be stripped causing an air flow problem.
Dryer drum roller axle. If the dryer is noisy this roller axle or the roller itself may be worn and require replacement.
Dryer front drum support glide. Order 2 when repairing the dryer. Be aware it requires a rivet tool to install the new glide and the tool must be purchased locally.
Dryer slide in lint filter (lint trap). Proper air flow is critical to dryer operation so the filter should be cleaned before every load. Replace the filter if it has any tears or rips in it.
Washer belt kit for Maytag models. If the washer does not agitate, spin, or drain then one of the belts could be worn and require replacement. Belt sizes: 41 in x 5/16 in, 42-1/3in by 7/16 in
Snap retaining ring. Used to keep rollers and idler wheels in place
High temperature adhesive for installing rubber feet and felt seals, 2 ounces.
Spanner nut wrench for many Whirlpool, Kenmore, General Electric & Maytag inner tub lock (spanner) nuts
White silicone adhesive caulk. Forms a heat resistant bond. Often used for gaskets, seals and burner grate feet.
Dryer idley pulley. The idler pulley puts tension on the drive belt. If the idler pulley fails to put the proper amount of tension on the belt, the dryer will not spin.
Dryer door catch kit. Includes door catch and clip (plastic)
Three terminal door switch kit. Be aware that this switch replaces older 2 terminal switches.
Start doing it yourself with the confidence that comes with 100+ years of experience. We've got millions of parts, hundreds of brands, and thousands of step-by-step videos— everything you need to find it, fix it and finish the job right.
