Washing machine agitator directional cogs. These parts are also referred to as "dog ears." 4 per package. If the upper section of the agitator isn't turning properly, then these cogs are likely worn and will require replacement.
Washing machine agitator repair kit with a medium length cam (there are other kits available for different models). This kit should be used when the top part of the agitator is not moving properly but the bottom part is.
Washing machine drain pump. The pump mounts directly to the motor with two clips. If the washer does not drain then the pump could be locked up or a small object may be clogging it. A small leak in front of the washer could be caused by a defective pump.
Washing machine suspension spring. If the suspension spring is broken, the washer will be off balance.
White touch-up paint. .6 oz.
Direct drive washer lid switch assembly, If the washing machine does not spin the lid switch may have failed.
Transmission (gearbox) for direct-drive washing machines. If the gears inside the transmission are worn out, the washer may not spin.
Washer agitator bolt with rubber gasket and thread sealant. Head is 7/16 inches in diameter.
Spanner nut wrench for many Whirlpool, Kenmore, General Electric & Maytag inner tub lock (spanner) nuts
Water inlet valve and inlet assembly with thermistor for water temp sensing. The water inlet valve opens to allow water to enter the washing machine. If the water inlet valve is defective, the wash may fill slowly or not fill at all.
Fabric softener dispenser, white, measures approximately 5" round x 4 1/4" tall
Washing machine main tub seal
Adjustable leveling leg for washing machine. This leveling leg has a rubber foot. If the leveling leg is not adjusted properly, the washer will be off-balance and will vibrate or shake during operation.
Agitator inner cap and seal. Helps keep water, fabric softener from going thru the agitator. Fabric softner dispenses from the holes in the agitator, just above the cap.
Package of two 5-foot-long Industrial Braid hoses with pre-installed washers and straight ends. It is recommended to replace washing machine inlet hoses after 5 years of use to reduce the risk of hose failure.