Kenmore Washer/Dryer Combo Model 110.99575820 Parts

Kenmore Washer/Dryer Combo Model 110.99575820 Parts
Brand:Kenmore
Model:110.99575820
Product:Washer/Dryer Combo

Featured parts for Kenmore Washer/Dryer Combo

315 results
Go
Watch Video
$17.93

Dryer thermal fuse located on the blower housing. If the dryer overheats, the thermal fuse blows cutting off power to the motor or the heating system. When the fuse is bad the dryer won't start or will run but not heat. The thermal fuse cannot be reset. Fuses often blow due to a clogged dryer vent.

Watch Video
$21.70

Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.

Watch Video
$19.15

Washer drive motor coupler. New style with metal sleeves for added strength. This version replaces all previous motor coupler styles and versions. For direct drive washing machines. Common symptom of failed coupler is washer will fill, not agitate or spin but will drain the water from the tub.

Watch Video
$15.16
24% Off MSRP: $19.95

Rear drum support roller kit. This kit contains two drum support rollers. If the drum rollers are worn out, the dryer may not turn properly or may be excessively noisy. Be aware that the drum bearings are self-lubricating; it is not necessary to lubricate them yourself.

Watch Video
$3.55
15% Off MSRP: $4.20

Washing machine agitator directional cogs. These parts are also referred to as "dog ears." 4 per package. If the upper section of the agitator isn't turning properly, then these cogs are likely worn and will require replacement.

Watch Video
$5.96
56% Off MSRP: $13.45

Dryer door catch kit. This kit includes three different door catches; you will need to select the door catch that fits your model.

Watch Video
$36.26
25% Off MSRP: $48.48

Washing machine clutch assembly with hardware. *Blue spring for large capacity washers, black for compacts. A worn clutch often causes a slower spin speed which leaves the clothes soaked after the cycle.

Watch Video
$48.34

Washing machine drain pump. The pump mounts directly to the motor with two clips. If the washer does not drain then the pump could be locked up or a small object may be clogging it. A small leak in front of the washer could be caused by a defective pump.

Watch Video
$44.18

Dryer igniter kit. This igniter will replace both round and flat style igniters. The kit includes the bracket, wire nuts and mounting screw. Be aware the igniter is very fragile and should be handled carefully.

Watch Video
$20.51

Dryer belt tension idler pulley assembly.When the idler pulley goes bad it will usually make a high pitch squeeling or rattling noise.

Watch Video
$19.29

Spanner nut wrench for many Whirlpool, Kenmore, General Electric & Maytag inner tub lock (spanner) nuts

Watch Video
$36.87

Washing machine water inlet valve kit with bracket. A long or slow fill cycle is often due to a restricted water valve. The valve should never be disassembled and cleaned, only replaced.

Watch Video
$12.16

Dryer tri-ring retainer for drum support rollers.

Watch Video
$13.06

5-foot-long rubber fill hose for washing machines. Used for hot or cold water.

Watch Video
$36.11
8% Off MSRP: $39.36

Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.

Go
Related Articles & Videos
Common Problems
With most appliances and equipment there are only a handful of problems that crop up. Since 1912, we've learned to recognize the most common problems ― and their solutions. Do any of these look familiar?