Dryer idler pulley wheel. If the pulley wheel is worn down, it may cause the dryer to be excessively noisy.
Rear drum bearing kit. *Bearing plate has slot in it for ground strap. The drum bearing supports the rear of the dryer drum. Over time, the drum bearing wears out. If the drum bearing is worn out, the dryer may make noise.
Dryer drive belt. This is the most common GE/Hotpoint dryer belt. 87" long and 1/4" wide. 4 ridges.The drive belt dries out over time. If the dryer belt cracks or breaks, the dryer drum will not be able to turn. If the dryer motor is running, but the drum won't rotate, the belt has likely broken.
Gas dryer igniter assembly with bracket and wire harness. If the dryer does not heat then the igniter may have burned out. The burned spot is normally visible. Be aware the igniter is very fragile.
Light bulb, 120V, 10W
Dryer door catch kit
Handle, white. Snaps in place
Dryer door strike.
Dryer lint filter assembly.
Dryer gas valve solenoid coil. Has two terminals.
Gas valve solenoid coil 3 terminal
Drum front drum slide. This drum slide helps to support the front of the dryer drum as it rotates.. If the drum slides are worn out, the dryer will become noisy during operation. Because the drum slides wear out at the same rate, we recommend replacing all of the slides at the same time.
Dryer motor kit. Replaces old "T" & "V" style motors. Includes 2 motor pulleys and basic directions. Common symptoms of a bad drive motor are:
-Dryer stops turning during cycle
-Dryer won't start
-Dryer won't turn at al
Flame sensor assembly for gas dryer
Blower wheel for dryer