Watch Video $46.30
34% Off MSRP: $69.74
Washing machine tub suspension rod kit,. Set of 4 rods, 4 suspension balls and 4 bushings. The suspension rods help to dampen the movement of the washer tub. If one or more of the suspension rods are broken, the washer will vibrate or shake.
Watch Video $38.61
25% Off MSRP: $51.68
Includes latch assembly, one white and one gray lid lock bezel. Lid must be closed for washer to fill, wash, drain, or spin. If the machine is not advancing into the cycle or is displaying a lid lock fault this may be the cause of the issue.
Washer main drive belt. This belt is located under the washing machine and is used to drive the splutch pulley. It goes around the motor & splutch pulleys. Worn or broken drive belt can cause spin or washplate problems.
Watch Video $33.68
5% Off MSRP: $35.63
Drive Clutch Kit. This kit has 6 parts; a spring, housing, cam ring, basket drive gear, pulley, and nut. The pulley is driven by the drive belt and the splutch works with the mode shift actuator to operate the washplate and spin the inner basket. A worn splutch can cause spin or washplate problems.
Spanner nut wrench for many Whirlpool, Kenmore, General Electric & Maytag inner tub lock (spanner) nuts
Watch Video $51.04
8% Off MSRP: $55.47
Washing machine mode shift actuator. *Updated by the manufacturer, does not look like original part. Actuator serves several functions. It has a synchronous motor that shifts the splutch cam ring and monitors the position of the splutch. Also has transmission speed/position optical sensor
Watch Video $13.53
17% Off MSRP: $16.34
Washer drive block for inner tub. A worn drive block may cause the washer to spin slowly, causing the clothes to be soaked at the end of the cycle. The washer may also make a loud knocking noise at the beginning of the spin cycle.
Watch Video $13.66
23% Off MSRP: $17.79
Washing machine agitator repair kit. Includes agitator cam and 4 directional cogs (also called dog ears). If the upper section of the agitator isn't turning properly, then the agitator cam and dog ears are likely worn-out and require replacement.
White washer lid strike assembly. The strike is what the lid lock hooks onto to lock the washing machine lid. If the washing machine is not advancing into the cycle or is displaying a lid lock fault this may be the cause of the issue.
Washing machine drain hose kit. Includes clamp. 4 feet long
Washing Machine Agitator repair kit with reversing dog ears and, long cam, and retainer. If the upper section of the agitator does not work then the cam and dog ears are likely worn and require replacement.
Package of two 5-foot-long Industrial Braid hoses with pre-installed washers and straight ends. It is recommended to replace washing machine inlet hoses after 5 years of use to reduce the risk of hose failure.