Kenmore Dryer Model 110.78087701 Parts

Kenmore Dryer Model 110.78087701 Parts
Brand:Kenmore
Model:110.78087701
Product:Dryer
Subtype:Gas

Featured parts for Kenmore Dryer

172 results
Go
Watch Video
$17.44
20% Off MSRP: $21.80

Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.

Watch Video
$13.98
13% Off MSRP: $16.10

Dryer drum support roller. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.

Watch Video
$43.55

Dryer lint filter. Air flow is vital to proper dryer operation. The lint filter should be cleaned before every load and replaced if damaged.

Watch Video
$28.26
31% Off MSRP: $41.18

Dryer igniter kit. This igniter will replace both round and flat style igniters. The kit includes the bracket, wire nuts and mounting screw. Be aware the igniter is very fragile and should be handled carefully.

Watch Video
$6.10

Dryer door catch. If the dryer door does not latch closed then the door strike or this catch is likely damaged.

Watch Video
$7.83

Dryer tri-ring retainer for drum support rollers.

Watch Video
$20.76
6% Off MSRP: $21.99

Dryer LP conversion kit; Natural gas to LP (liquid propane). This kit includes the orifice, leak limiter, and instruction sheet.

Watch Video
$35.31

Dryer thermistor. This thermistor should read approximately 11.9K Ohms of resistance at 70 degrees Fahrenheit (21’ Celsius). If the thermistor is defective, it may prolong or shorten the drying time or cause a fault code. A defective thermistor is not responsible for a dryer not heating.

Watch Video
$15.01
17% Off MSRP: $17.99

Dryer thermal fuse (or thermal limiter). This fuse is located on the exhaust duct. If the dryer overheats, the thermal fuse opens to cut off power to the dryer. The thermal fuse cannot be reset--if the thermal fuse is open, it must be replaced.

Watch Video
$6.90

Dryer moisture sensor bar. This moisture sensor monitors the clothing’s moisture level and sends a signal to the control board when the clothes are dry. If your moisture sensor is defective, the dryer may shut off too early or continue running for a while after the clothes are dry. Two required.

Watch Video
$30.40
23% Off MSRP: $39.36

Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.

Watch Video
$30.01

Dryer idler wheel and bracket assembly. Provides tension to the dryer drum belt.

Watch Video
$17.61

Cleaning brush for refrigerators, freezers, dryers and more. This brush is perfect for cleaning condenser coils on refrigeration systems. It is important to regularly clean the condenser coil to ensure the refrigerator is running efficiently.

Go
Related Articles & Videos
Common Problems
With most appliances and equipment there are only a handful of problems that crop up. Since 1912, we've learned to recognize the most common problems ― and their solutions. Do any of these look familiar?
Dryer won't start
8 possible causes and potential solutions
Dryer won't start
Dryer stopped spinning
5 possible causes and potential solutions
Dryer stopped spinning
Dryer drum not turning
6 possible causes and potential solutions
Dryer drum not turning