Kenmore Dryer Model 110.97721700 Parts

Kenmore Dryer Model 110.97721700 Parts
Brand:Kenmore
Model:110.97721700
Product:Dryer
Subtype:Gas

Featured parts for Kenmore Dryer

196 results
Go
Watch Video
$11.55
23% Off MSRP: $14.95

Dryer thermal fuse located on the blower housing. If the dryer overheats, the thermal fuse blows cutting off power to the motor or the heating system. When the fuse is bad the dryer won't start or will run but not heat. The thermal fuse cannot be reset. Fuses often blow due to a clogged dryer vent.

Watch Video
$17.44
20% Off MSRP: $21.80

Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.

Watch Video
$13.98
13% Off MSRP: $16.10

Dryer drum support roller. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.

Watch Video
$17.66
26% Off MSRP: $23.88

Dryer idler pulley assembly.

Watch Video
$22.51

Dryer drum drive belt, 93 1/2 inches long, 4 ribs 3 grooves. The drive belt is a very long, slender belt that wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.

Watch Video
$43.55

Dryer lint filter. Air flow is vital to proper dryer operation. The lint filter should be cleaned before every load and replaced if damaged.

Watch Video
$5.37
60% Off MSRP: $13.45

Dryer door catch kit. This kit includes three different door catches; you will need to select the door catch that fits your model.

Watch Video
$28.26
31% Off MSRP: $41.18

Dryer igniter kit. This igniter will replace both round and flat style igniters. The kit includes the bracket, wire nuts and mounting screw. Be aware the igniter is very fragile and should be handled carefully.

Watch Video
$7.83

Dryer tri-ring retainer for drum support rollers.

Watch Video
$20.76
6% Off MSRP: $21.99

Dryer LP conversion kit; Natural gas to LP (liquid propane). This kit includes the orifice, leak limiter, and instruction sheet.

Watch Video
$35.31

Dryer thermistor. This thermistor should read approximately 11.9K Ohms of resistance at 70 degrees Fahrenheit (21’ Celsius). If the thermistor is defective, it may prolong or shorten the drying time or cause a fault code. A defective thermistor is not responsible for a dryer not heating.

Watch Video
$6.90

Dryer moisture sensor bar. This moisture sensor monitors the clothing’s moisture level and sends a signal to the control board when the clothes are dry. If your moisture sensor is defective, the dryer may shut off too early or continue running for a while after the clothes are dry. Two required.

Watch Video
$30.40
23% Off MSRP: $39.36

Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.

Watch Video
$22.50

Dryer idler pulley. The idler pulley puts tension on the drive belt. If the idler pulley fails to put the proper amount of tension on the belt, the dryer will not spin.

Go
Related Articles & Videos
Common Problems
With most appliances and equipment there are only a handful of problems that crop up. Since 1912, we've learned to recognize the most common problems ― and their solutions. Do any of these look familiar?
Dryer won't start
7 possible causes and potential solutions
Dryer won't start
Dryer stopped spinning
5 possible causes and potential solutions
Dryer stopped spinning
Dryer drum not turning
7 possible causes and potential solutions
Dryer drum not turning