Keep your pressure washer (a.k.a. power washers) working well by completing a few simple maintenance steps before storing it for the winter.
Here’s how to winterize your pressure washer:
1. Review your pressure washer ownerâ€™s manual for care instructions specific to your model.
2. Install a clean air filter.
The air filter must be clean in order to effectively prevent dirt, dust and other harmful debris from entering the engine. Every four hours of use, clean the filter. Every 100 hours of use or every three months, replace it. Pleated, paper air filters cannot be cleaned without damage so they should be replaced. Foam air filters can be cleaned with hot water and a small amount of dish detergent. When the filter is completely dry, saturate it with engine oil before reinstalling it. NOTE: Do not use oil on a foam filter if your model also uses a paper element filter.
3. Clean the fuel filter (following the ownerâ€™s manualâ€™s instructions, as the procedure does vary from model to model).
4. Check the oil.
Replace the oil if it becomes too dark â€“ or at least every 50 hours of use or once per season.
5. Clean the water inlet screen.
Check the water inlet screen for dirt and debris buildup. Rinse it with water. Allow it to dry thoroughly before returning it to the pressure washer. If the screen is damaged at all, replace it.
5. Inspect the tires.
Check the tires for wear or damage and replace if necessary.
6. Add an anti-freeze and lubricant formula to fresh fuel. My favorite is Briggs & Stratton Pump Saver. This will keep internal parts lubricated and prevent pump cracking during storage.
7. Store in a clean, dry location, far away from open flames or sparks.
Something wrong with your pressure washer? Check out RepairClinic.com’s troubleshooting and repair help information for pressure washers. Enter your pressure washer’s model number for a complete list of replacement parts.