DescriptionThis video provides step-by-step repair instructions for replacing the freezer ice bucket on an LG refrigerator. The most common reason for replacing the ice maker assembly is when ice maker isn’t working.
All of the information for this ice maker assembly replacement video is applicable to the following brands:
LG, Kenmore
Tools needed: multi-screwdriver, Phillips head bit, small flathead screwdriver
Step-By-Step Instructions1
As with any repair, you should unplug the power cord before beginning.
2
To replace the icemaker assembly in your freezer, first pull out the lower drawer.
3
Next, remove the screws securing the lower drawer assembly to the rails.
4
Remove the drawer bin by lifting it up from the rear.
5
Lift off the drawer assembly from the rails and set it aside.
6
Push the lower slide rails in and pull out the upper drawer.
7
Depress the tabs on the upper drawer supports and lift the upper drawer off.
8
Remove the mounting screws securing the icemaker assembly to the cabinet.
9
Use a small flathead screwdriver to depress the tabs to detach the assembly then pull the assembly forward.
10
Depress the tab to disconnect the wire harness to fully release the old icemaker.
11
You’re now ready to install the new icemaker assembly.
12
Connect the wire harness to the receptacle in the liner.
13
Slide the new assembly into position and snap it into place.
14
Reinstall the mounting screws.
15
Pull the upper slide rails out align the upper drawer on the supports and snap it into position.
16
Reinstall the lower drawer assembly by first pulling out the slide rails.
17
Now align the rear tabs on the drawer assembly with the rear slots on the rails then insert the front tabs into the front slots.
18
Replace the drawer bin by aligning the lip of the bin with the tabs and lower the bin into place.
19
Replace the screws to secure the drawer assembly to the rails.
20
You’re now ready to plug the power cord back in switch on the new icemaker and confirm that it works properly.