This video provides step-by-step repair instructions for replacing the door spring on a Danby dishwasher. The most common reason for replacing the door spring is when it is broken or damaged.
All of the information for this dishwasher door spring replacement video is applicable to the following brands: Danby Tools needed: 5/8" wrench, adjustable wrench, Phillip's head screwdriver, 5/16" nut driver Step-By-Step Instructions 1 To replace a door spring on your dishwasher, you will need to pull the dishwasher a few inches away from the cabinet. 2 Detach the lower access panel and determine if the water and power supply lines provide enough slack to do this. If not, you will need to fully uninstall the appliance. 3 Turn off the power to your dishwasher 4 Shut off the water supply valve. 5 Use a 5/8th inch wrench or an adjustable wrench to help unthread the water supply line from the inlet valve elbow fitting be prepared for some water to spill. 6 Next, use a phillips-head screwdriver to unthread the screw securing the junction box cover. Then pull the cover off. 7 Note the location of the wires then untwist the wire nuts to disconnect the wires. 8 Unthread the strain relief nut if applicable and detach the strain relief from the junction box. 9 Next, disconnect the drain hose from the sink drain or garbage disposer and feed it through the cabinet. 10 Open the dishwasher door and remove the mounting bracket screws. 11 To move the dishwasher, you may need to adjust the legs to lower the appliance. 12 Very carefully pull the dishwasher away from the cabinet. 13 Remove the old door spring if still intact. 14 Prepare the new door spring for installation by applying a small amount of grease. 15 Now hook the short end onto the adjustment pin and the long end onto the hinge. 16 Confirm that the door opens and closes properly. 17 Make sure the end of the drain hose is accessible through the cabinet wall then gently slide the dishwasher back into the cabinet. 18 Adjust the leveling legs if necessary. 19 Replace the screws to secure the mounting brackets to the cabinet or countertop. 20 Feed the drain hose through the cabinet and connect it to the sink drain or disposer. 21 Make sure the hose is elevated above the connection point. 22 Fully position the wire strain relief in the junction box and secure the strain relief nut if applicable. 23 Connect the wires and secure them with the wire nuts. 24 Align the cover and replace the screw to secure. 25 Reconnect the water supply line to the inlet valve elbow fitting. 26 Realign the lower access panel and snap it into place. 27 With the repair completed, turn the water supply back on as well as the power and your dishwasher should be ready for use.