Shipping all 7 days! Hold times are long. Already ordered? Email [email protected]Learn more

Echo Leaf Blower Trigger Spring Replacement (V452001630)

02:34
1.1k
1
This video provides step-by-step instructions for replacing the trigger spring on Echo leaf blowers.

Step By Step Instructions

1
Leaf Blower- Model PB580T
2
Leaf Blower Throttle Trigger Spring Replacement
3
"Step 1: Unthread the retaining knob screw to release the throttle control from the blower tube clamp. "
4
Step 2: Use a T-27 Torx bit to unthread the four screws securing the two halves of the throttle cable.
5
Step 3: Lift off the right half.
6
Step 4: Lift out the trigger and detach the throtte cable.
7
Step 5: Remove the old spring if still intact.
8
Step 6: Install the new throttle trigger spring by inserting the hooked end into the hole then position the spring on the trigger hub.
9
Step 7: Reattach the throttle cable.
10
"Step 8: Keeping the spring depressed, align the trigger on the post. "
11
Step 9: Confirm the wires and cable retainer are positioned in the channel and make sure the mounting pin is in place.
12
Step 10: Realign the two halves of the throttle control and thread the screws.
13
Step 11: Reposition the throttle control in the blower tube clamp then thread and tighten the retaining knob screw.
14
Attention: You can rotate the throttle cable adjustment screw clockwise to increase tension on the cable or counter-clockwise to decrease the tension.
15
Congratulations! Your lead blower should be ready for use.
Description
This video provides step-by-step instructions for replacing the trigger spring on Echo leaf blowers.
Step-By-Step Instructions
1
Leaf Blower- Model PB580T
2
Leaf Blower Throttle Trigger Spring Replacement
3
"Step 1: Unthread the retaining knob screw to release the throttle control from the blower tube clamp. "
4
Step 2: Use a T-27 Torx bit to unthread the four screws securing the two halves of the throttle cable.
5
Step 3: Lift off the right half.
6
Step 4: Lift out the trigger and detach the throtte cable.
7
Step 5: Remove the old spring if still intact.
8
Step 6: Install the new throttle trigger spring by inserting the hooked end into the hole then position the spring on the trigger hub.
9
Step 7: Reattach the throttle cable.
10
"Step 8: Keeping the spring depressed, align the trigger on the post. "
11
Step 9: Confirm the wires and cable retainer are positioned in the channel and make sure the mounting pin is in place.
12
Step 10: Realign the two halves of the throttle control and thread the screws.
13
Step 11: Reposition the throttle control in the blower tube clamp then thread and tighten the retaining knob screw.
14
Attention: You can rotate the throttle cable adjustment screw clockwise to increase tension on the cable or counter-clockwise to decrease the tension.
15
Congratulations! Your lead blower should be ready for use.

Applicable Product Model

Parts Needed
Spring
Spring
$1.36
Total$0.00

Related Articles & Videos