This video provides step-by-step instructions for replacing the 6-inch surface element on Frigidaire electric ranges.
All of the information in this video is applicable to the following brands: Frigidaire Step-By-Step Instructions 1 Frigidaire Electric Range - Model LFEF3054TFG 2 Electric Range 6-Inch Surface Element Replacement 3 Tools & Assistance Needed 4 "You will need a phillips-head screwdriver, a towel or blanket and pliers for this procedure, and you may need assistance." 5 Be sure to unplug the power cord or shut off the power supply. 6 Open the oven door and use a phillips-head screwdriver to unthread the two screws securing the front of the main top. 7 Pull the main top forward and have an assistant hold it as you place a towel or blanket underneath. 9 Now unthread the screws securing the rear surface element support brace. 10 "Gently rest the surface elements and brace on the towel or blanket, then notate which slots the surface element retaining clips are inserted into." 11 Use pliers to depress the tabs to release the retaining clips from the brace. 12 Note the orientation of the element wiresâ€¦then disconnect them. 13 Prepare the new surface element for installation by transferring the retaining clips from the old element to the new one. 14 Use the numbers engraved on the base to position the clips in the proper locations. 15 Connect the wires to the appropriate terminals. 16 Insert the retaining clips into the appropriate slots in the support brace. 17 Realign the support brace on the main top and thread the screws to secure. 18 "Remove the towel or blanket, then insert the main topâ€™s rear mounting clips into the support panel slots." 19 "Align the rear edges of the main top under the frame clips, then thread and tighten the front screws." 20 Plug the power cord back in or restore the power supply. 21 Congrats! Your electric range is ready for use.