This video provides step-by-step instructions for replacing the inner oven door glass on Frigidaire gas ranges.
All of the information in this video is applicable to the following brands: Frigidaire Tools used: Phillips-head screwdriver, & a quarter-inch socket or nut driver. Step-By-Step Instructions 1 Frigidaire Gas Range - Model FFGF3052TSA 2 Gas Range Inner Oven Door Glass Replacement 3 Tools & Assistance Needed 4 "You will need a towel or blanket, a phillips-head screwdriver and a quarter-inch socket or a square drive bit for this procedure, and you may need assistance." 5 Be sure to unplug the power cord or shut off the power supply. 6 Fully open the oven door and rotate both door hinge locks back. 7 Partially close the door then lift and pull the door toward you to remove. 8 Set the door handle-side down on a towel or blanket. 9 "Using a phillips-head screwdriver, unthread the four bottom screws securing the outer door panel." 10 Unthread the two upper screws securing the door handle and the inner panel assembly. 12 Separate the inner door assembly from the outer panel. 13 "Using a quarter-inch socket or a square drive bit, unthread the four screws securing the retaining panel." 15 "Remove the panel and lift out the old inner door glass from the frame, if thatâ€™s the glass youâ€™re replacing." 16 "Otherwise, set the glass and frame aside and remove the glass positioned in the inner panel." 17 "Install the new inner oven door glass by positioning it in the panel, or align it in the frame." 18 Reinstall the retaining panel by aligning the bottom edge first. 19 Rethread the screws to secure. 20 Join the inner door assembly and the outer door panel together. 21 Realign the handle and fully thread the upper screws to secure it. 22 Replace the four bottom screws. 23 Reinstall the oven door by inserting the door hinges into the hinge slots at a forty-five degree angle. 24 Lower the door to its fully open position then rotate the hinge locks forward. 25 Plug the power cord back in or restore the power supply. 26 Congrats! Your gas range is ready for use. 27 Align the hinges with the inner panel and rethread the screws. 28 Realign the handle and fully thread the upper screws to secure it. 29 Reinstall the oven door by inserting the door hinges into the hinge slots at a forty-five degree angle. 30 Plug the power cord back in or restore the power supply.