Shipping all 7 days! Hold times are long. Already ordered? Email [email protected]Learn more

Whirlpool/Kenmore Electric Dryer Terminal Block #3397659

01:30
28k
43
This video provides step-by-step repair instructions for replacing the terminal block on a Whirlpool/Kenmore electric dryer. The most common reasons for replacing the terminal block are when the dryer trips the breaker or the dryer doesn’t work at all.

All of the information for this terminal block replacement video is applicable to the following brands:
Whirlpool, Kenmore, Maytag, Roper, KitchenAid, Crosley, Estate, Amana, Inglis, Admiral

Tools needed: hex socket, flat head screwdriver, Phillips head screwdriver

Step By Step Instructions

1
As with any repair, be sure you’ve unplugged the appliance before beginning.
2
Your first step is to remove the power cord access panel.
3
Once the panel is off, be sure to note the correct location of all wires before continuing.
4
Next, remove the screws to release the power cord wires then remove the two mounting screws to detach the old terminal block.
5
Using a small flathead screwdriver, push down the tab in the back to release each of the three terminal block wires then, remove the three terminal nuts.
6
Install the new terminal block by inserting the nuts into the block and reattaching each wire in its appropriate slot.
7
Secure the block with the mounting screws.
8
Reinstall the power cord wires.
9
Replace the access panel and plug the appliance back in to make sure it’s functioning properly.
Description
This video provides step-by-step repair instructions for replacing the terminal block on a Whirlpool/Kenmore electric dryer. The most common reasons for replacing the terminal block are when the dryer trips the breaker or the dryer doesn’t work at all.

All of the information for this terminal block replacement video is applicable to the following brands:
Whirlpool, Kenmore, Maytag, Roper, KitchenAid, Crosley, Estate, Amana, Inglis, Admiral

Tools needed: hex socket, flat head screwdriver, Phillips head screwdriver
Step-By-Step Instructions
1
As with any repair, be sure you’ve unplugged the appliance before beginning.
2
Your first step is to remove the power cord access panel.
3
Once the panel is off, be sure to note the correct location of all wires before continuing.
4
Next, remove the screws to release the power cord wires then remove the two mounting screws to detach the old terminal block.
5
Using a small flathead screwdriver, push down the tab in the back to release each of the three terminal block wires then, remove the three terminal nuts.
6
Install the new terminal block by inserting the nuts into the block and reattaching each wire in its appropriate slot.
7
Secure the block with the mounting screws.
8
Reinstall the power cord wires.
9
Replace the access panel and plug the appliance back in to make sure it’s functioning properly.

Applicable Product Model

Parts Needed
Recommended Tools and Accessories
Total$0.00

Related Articles & Videos