• 1-800-269-2609
  • En Español
  • Available 7 days a week

Chainsaw Starts Then Stalls

The chainsawsmall engine often has a separate model number. Use the small engine model number for a complete list of symptoms and parts. Watch our model # lookup video for help finding the model number.

The part(s) or condition(s) listed below for the symptom Chainsaw starts then stalls are ordered from most likely to least likely to occur. Check or test each item, starting with the items at the top of the page.

Most Frequent Causes for Chainsaw starts then stalls

For the most accurate results, enter your model number.


Cause 1Spark Arrestor

The spark arrestor is a small screen that prevents the engine from emitting sparks. Over time, the spark arrestor can become clogged with soot. If the spark arrestor is clogged, the chainsaw may run stall or run rough. To unclog the spark arrestor, remove it and clean it with a wire brush. You can also replace the spark arrestor.

Parts
Cause 2Carburetor

The carburetor might be clogged. A clogged carburetor is often caused by leaving fuel in the chainsaw for a long period of time. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the carburetor and cause the chainsaw engine to stall. If the carburetor is clogged, try cleaning it with carburetor cleaner. If cleaning the carburetor isn’t effective, rebuild or replace the entire carburetor.

Parts
Cause 3Carburetor Repair Kit

The carburetor might be clogged. A clogged carburetor is often caused by leaving fuel in the chainsaw for a long period of time. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the carburetor and cause the chainsaw engine to stall. If the carburetor is clogged, try cleaning it with carburetor cleaner. If cleaning the carburetor isn’t effective, rebuild or replace the entire carburetor.

Parts
Cause 4Fuel Filter

The fuel filter might be clogged. A clogged fuel filter is often caused by leaving old fuel in the chainsaw. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the fuel filter and cause the engine to stall. If old fuel was left in the chainsaw, drain the old fuel from the fuel tank and replace the fuel filter.

Parts
Cause 5Air Filter

The air filter may be clogged or dirty. If the air filter is clogged, the engine will get too much fuel and not enough air. As a result, the engine may stall or run roughly. Inspect the air filter to determine if it is clogged. If the air filter is clogged, replace it.

Parts