• 1-800-269-2609
  • En Español
  • Available 7 days a week

Maytag Dryer Won't Start

LDG7304AAE

The part(s) or condition(s) listed below for the symptom Dryer won't start are ordered from most likely to least likely to occur. Check or test each item, starting with the items at the top of the page.

Most Frequent Causes for Dryer won't start

Cause 1Thermal Fuse

The thermal fuse is a safety device designed to protect the dryer from overheating. The fuse is located on the blower housing or at the dryer’s heat source such as the heating element on electric dryers or at the burner on gas models. The fuse should be closed for continuity meaning it has a continuous electrical path through it when good. If overheated the fuse will have no continuity meaning the electrical path is broken and the fuse has blown out. A multimeter can be used to test it for continuity. Be aware that a blown thermal fuse is an indication of a restricted exhaust vent from the dryer to the outside. Always check the dryer venting when replacing a blown thermal fuse.

Part Testing
Parts
Thermal Fuse for your MaytagDryer
Thermal Fuse - Part # 483890 Mfg Part # WP306604

Dryer thermal fuse. If the dryer overheats, the thermal fuse blows to cut off the power to the dryer. If the thermal fuse has blown, the dryer won't start. Thermal fuses cannot be reset.

Add to Cart
Cause 2Door Switch

The door switch activates when the dryer door is closed. On most dryers, the door switch makes an audible clicking sound when it activates. To determine if the door switch is working, try starting your dryer and then listen for the “click.” If the door switch makes a clicking sound, it is probably not defective. If you don’t hear a click, use a multimeter to use the door switch for continuity. If the switch does not have continuity, replace it.

Part Testing
Parts
Door Switch for your MaytagDryer
Door Switch - Part # 1378530 Mfg Part # W10169313

Three terminal door switch kit. Be aware that this switch replaces older 2 terminal switches.

Add to Cart
Install Help
Cause 3Drive Motor

The drive motor turns the drum and the blower wheel to exhaust the air. Before replacing the motor, first check the thermal fuse, start switch, and door switch. If all of these parts are working properly, but the motor is making a humming noise, remove the belt from the motor and check the blower wheel for obstructions. If the blower wheel is clear of obstructions, the dryer motor might be at fault. If you suspect the motor is defective, replace it.

Parts
Drive Motor for your MaytagDryer
Drive Motor - Part # 2118676 Mfg Part # W10410999

Dryer drum drive motor. New style motor switch, see included instructions for details. The motor will need re-wiring.
Common symptoms of a bad drive motor are:
-Dryer stops turning during cycle
-Dryer won't start
-Dryer won't turn at all

Add to Cart
Install Help
Cause 4Drive Belt

On most dryers, when the dryer belt breaks, the motor will still run, but the drum will not turn. However, some dryers have a switch that shuts off power to the dryer if the drive belt is broken. Check the dryer belt to determine if it is broken. If the belt is broken, replace it.

Parts
Drive Belt for your MaytagDryer
Drive Belt - Part # 1246110 Mfg Part # WPY312959

Dryer drum drive belt, 100 inches long, 3/8" wide,5 ribs 4 grooves. The drive belt wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.

Add to Cart
Install Help
Cause 5Incoming Power Problem

If you have a gas dryer, unplug the dryer from the wall and plug something else into the outlet to determine if the outlet is working. If you have an electric dryer, check the home circuit breaker or fuses. If the circuit breaker or fuses are working, use a multimeter to test the outlet.

Cause 6Timer

The timer might be defective. However, this is very rarely the case. Before replacing the timer, check all the more commonly defective parts. If you have determined that all of the other components are working properly, replace the timer. (The timer cannot be tested, so it is not possible to directly determine if it is defective.)

Parts
Timer for your MaytagDryer
Add to Cart