• 1-800-269-2609
  • En Español
  • Available 7 days a week

Maytag Dryer Stopped Spinning

DG808

The part(s) or condition(s) listed below for the symptom Dryer stopped spinning are ordered from most likely to least likely to occur. Check or test each item, starting with the items at the top of the page.

Most Frequent Causes for Dryer stopped spinning

Cause 1Drive Belt

The drive belt is a very long, slender belt that wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. Over time, the belt can break from normal use. If the belt is broken, the dryer won’t turn. To quickly determine if the belt is broken, reach into the dryer and turn the drum by hand. If the drum spins very easily, the belt is likely broken. Next, inspect the belt to confirm that it is broken. If the belt is broken, replace it.

Parts
Drive Belt for your MaytagDryer
Drive Belt - Part # 1246110 Mfg Part # WPY312959

Dryer drum drive belt, 100 inches long, 3/8" wide,5 ribs 4 grooves. The drive belt wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.

Add to Cart
Install Help
Cause 2Drum Roller

One or more of the drum rollers might be worn out. Most dryers have two drum support rollers on the rear of the drum, and some dryers have two more rollers supporting the front of the drum. The rollers must spin freely to work properly. If the rollers don’t spin freely, the motor will get overloaded and the dryer will stop. If the drum rollers are worn out, the rollers may not spin freely. To determine if the support rollers are worn out, remove the belt from the dryer and try turning the drum by hand. If the drum does not rotate freely, check the support rollers for wear. If one or more of the rollers don’t turn freely, we recommend replacing all of the rollers at the same time as a preventative measure. (The roller shaft can often be reused if it is in good condition. Clean the shaft thoroughly before installing the new rollers.)

Parts
Drum Roller for your MaytagDryer
Drum Roller - Part # 400518 Mfg Part # 12001541

Dryer drum support roller kit. Includes two washers. When the drum rollers are worn out, they can cause the dryer to make a loud rumbling noise. Both rollers should be replaced at the same time. The roller does not need lubrication, the bearing is self lubricanting.

Add to Cart
Install Help
Cause 3Drum Slide, Glide, or Pad

If the dryer stops turning during the cycle, one or more of the drum glides (also called slides) might be worn out. The drum glides are small plastic pieces that support the front of the dryer drum. As the drum rotates, it slides on these plastic pieces. Over time, the drum glides wear out. If the drum glides are worn out, the drum can start binding and put strain on the motor. If this happens, the motor shuts down, preventing the dryer from turning. To determine if the drum glides are worn out, inspect them for wear. If the glides are worn out, replace all of the glides as a set.

Parts
Drum Slide, Glide, or Pad for your MaytagDryer
Drum Slide, Glide, or Pad - Part # 1309 Mfg Part # 306508

Dryer front drum support glide. Order 2 when repairing the dryer. Be aware it requires a rivet tool to install the new glide and the tool must be purchased locally.

Add to Cart
Install Help
Cause 4Drum Roller Axle

One or more of the drum roller axles might be worn out. Most dryers have two drum support rollers on the rear of the drum, and some dryers have two more rollers supporting the front of the drum. The rollers must spin freely to work properly. If the roller axles are worn out, the rollers may not spin freely, causing the motor to overload and the dryer to stop. To determine if the drum roller axles are worn out, remove the belt from the dryer and try turning the drum by hand. If the drum does not rotate freely, check the support rollers for wear. If the rollers spin freely without wobbling, the axles do not need to be replaced. If a roller wobbles and/or does not spin freely, we recommend replacing all of the axles and rollers as a preventative measure.

Parts
Drum Roller Axle for your MaytagDryer
Drum Roller Axle - Part # 1480353 Mfg Part # WP6-3129480

Dryer drum roller axle. If the dryer is noisy this roller axle or the roller itself may be worn and require replacement.

Add to Cart
Install Help
Cause 5Drive Motor

The drive motor turns the drum and the blower wheel to exhaust the air. If the dryer runs, stops for a while, and then starts again, this likely indicates that the motor is overheating, causing the dryer to shut off until the motor cools down. First, remove the belt from the motor and check the blower wheel to ensure that it is not obstructed. Next, with the belt removed, try rotating the drum by hand. If the drum does not rotate freely, determine what is causing the drum to bind. If the drum turns freely and the blower wheel is clear of obstructions, the drive motor might be defective. If you suspect the motor is at fault, replace it.

Parts
Drive Motor for your MaytagDryer
Drive Motor - Part # 2118676 Mfg Part # W10410999

Dryer drum drive motor. New style motor switch, see included instructions for details. The motor will need re-wiring.
Common symptoms of a bad drive motor are:
-Dryer stops turning during cycle
-Dryer won't start
-Dryer won't turn at all

Add to Cart
Install Help