• 1-800-269-2609
  • En Español
  • Available 7 days a week

Hotpoint Dryer Overheating

NBXR453EV0WW

The part(s) or condition(s) listed below for the symptom Dryer overheating are ordered from most likely to least likely to occur. Check or test each item, starting with the items at the top of the page.

Most Frequent Causes for Dryer overheating

Cause 1Heating Element

The heating element warms the air before the air enters the dryer drum. If the element is partially shorted out, it may produce heat continuously, even if the dryer has reached the proper temperature. When this happens, the dryer gets too hot. To determine if the heating element is at fault, use a multimeter to test each terminal for continuity to the case. If the heating element has continuity to the case, it is shorted out. If the heating element is shorted out, replace it.

Part Testing
Parts
Heating Element for your HotpointDryer
Heating Element - Part # 844418 Mfg Part # WE11M23

Dryer heating element assembly with housing. If the dryer does not heat check for a blown themal fuse or thermal cut out. Heating elements will often have a break in the coil element if defective.

Add to Cart
Cause 2Air Flow Problem

If the vent is clogged or partially clogged, it will restrict the airflow through the dryer, substantially increasing the drying time. To ensure proper dryer performance, you should clean your dryer’s venting system at least once per year.

Cause 3Cycling Thermostat

The cycling thermostat cycles the heat on and off to maintain the proper air temperature. If the thermostat is defective, it may keep the heat on too long, causing the dryer to get too hot. However, this is rarely the case. Before replacing the cycling thermostat check all the more commonly defective parts. If you have determined that all of the other components are working properly, test the thermostat by using a multimeter to test it for continuity. If the thermostat does not have continuity, replace it.

Part Testing
Parts
Cycling Thermostat for your HotpointDryer
Cycling Thermostat - Part # 276485 Mfg Part # WE4M216

Cycling thermostat with bias heater. On blower housing.

Add to Cart
Install Help
Cause 4Felt Seal

Most dryers have a felt seal at the front and rear of the drum to prevent heat from escaping the drum. If the seal is worn out or missing, the heat will not be drawn through the drum properly, causing the dryer to get too hot. Check the drum seal to ensure that it is creating a reliable seal around the drum. However, this is rarely the case. Before replacing the felt seal check all the more commonly defective parts. If you have determined that all of the other components are working properly, replace the felt seal.

Parts
Felt Seal for your HotpointDryer
Felt Seal - Part # 3290413 Mfg Part # WE09X20441

Dryer drum seal for the lower front.

Add to Cart
Install Help
Cause 5Blower Wheel

The blower wheel works with the drive motor to draw air into the dryer drum. Clumps of lint, socks, and small articles of clothing can escape the lint filter and get caught in the blower wheel. In addition, the blower wheel sleeve can wear out, allowing the blower wheel to wobble on the motor shaft. If the blower wheel is obstructed or defective, the dryer may get too hot. To determine if the blower wheel is working properly, remove the dryer vent and assess the strength of the air flow. If the air flow is weak, check the blower wheel for obstructions. If no obstructions are present, try rotating the blower wheel by hand. If the blower wheel wobbles as it turns, replace it.

Parts
Blower Wheel for your HotpointDryer
Blower Wheel - Part # 1089096 Mfg Part # WE16M15

Blower wheel for dryer

Add to Cart