• 1-800-269-2609
  • En Español
  • Available 7 days a week

Roper Dryer Tripping Breaker

RED4440VQ1

The part(s) or condition(s) listed below for the symptom Dryer tripping breaker are ordered from most likely to least likely to occur. Check or test each item, starting with the items at the top of the page.

Most Frequent Causes for Dryer tripping breaker

Cause 1The Circuit Breaker is Weak

Over time, circuit breakers can weaken. If the circuit breaker is weak, it may trip too often, even if the amperage draw is below the limit. If you have already checked all of the potentially defective dryer components, consider having an electrician replace the circuit breaker.

Cause 2Heating Element

Sometimes, if the heating element fails, it shorts out against the heater housing, causing the dryer to trip the circuit breaker. To determine if the heating element is at fault, use a multimeter to test each terminal for continuity to the case. If the heating element has continuity to the case, it is shorted out. If the heating element is shorted out, replace it.

Part Testing
Parts
Heating Element for your RoperDryer
Heating Element - Part # 2438 Mfg Part # 279838

Dryer heating element. If your dryer does not heat first check for a blown thermal fuse on the blower housing before replacing the heating element. In most cases the heating element will have a break in the element if defective.

Add to Cart
Install Help
Cause 3Drive Motor

Sometimes, when the drive motor fails, it shorts out internally, causing the dryer to trip the circuit breaker. To determine if the drive motor is at fault, use a multimeter to test it for continuity. If the motor windings are shorted out, replace the drive motor.

Parts
Drive Motor for your RoperDryer
Drive Motor - Part # 2584 Mfg Part # 279827

Dryer drum drive motor. Includes pulley for dryer drum drive belt. Other shaft has reverse threads for blower wheel. Common symptoms of a bad drive motor are:
-Dryer stops turning during cycle
-Dryer won't start
-Dryer won't turn at all
-Dryer drive motor is loud

Add to Cart
Install Help
Cause 4Terminal Block

Electric dryer power cords attach to the dryer at a terminal block. If any of the wires on the terminal block are loose, they can arc and destroy part of the block. If this happens, one of the wires can short against the body of the dryer, causing the dryer to trip the breaker. This is not a common occurrence.

Parts
Terminal Block for your RoperDryer
Terminal Block - Part # 527329 Mfg Part # WP3397659

Terminal block for power cord

Add to Cart
Install Help