• 1-800-269-2609
  • En Español
  • Available 7 days a week

Frigidaire Oven Not Heating

PLEB30T8CCB

The part(s) or condition(s) listed below for the symptom Oven not heating are ordered from most likely to least likely to occur. Check or test each item, starting with the items at the top of the page.

Most Frequent Causes for Oven not heating

Cause 1Bake Element

When the bake element is heating properly, it glows red hot. If the element does not glow red, this indicates that the element is not heating. Often, if the heating element has burned out, it will be visibly damaged. Inspect the heating element for holes or blisters. To determine if the bake element has burned out, use a multimeter to test the element for continuity. If the bake element does not have continuity, replace it.

Part Testing
Parts
Bake Element for your FrigidaireRange/Stove/Oven
Bake Element - Part # 2220750 Mfg Part # 318255006

Oven bake element. The terminals are male quarter inch spade connectors. The wires push onto the heating elements connectors. If the oven does not bake then the element could have burned out.

Add to Cart
Cause 2Broil Element

Inspect the broil element for holes or blisters. When the broil element is heating properly, it glows red hot. If the element does not glow red, this indicates that the element is not heating. Often, if the broil element has burned out, it will be visibly damaged. To determine if the broil element has burned out, use a multimeter to test the element for continuity. If the broil element does not have continuity, replace it.

Part Testing
Parts
Broil Element for your FrigidaireRange/Stove/Oven
Broil Element - Part # 2210952 Mfg Part # 318255605
Add to Cart
Install Help
Cause 3Incoming Power Problem

Electric ovens require 240 volts of alternating current. Gas ovens require 120 volts. If an oven won't turn on there could be an incoming power problem. To determine if the electrical outlet is providing sufficient voltage, use a multimeter to test the incoming power at the wall socket.

Cause 4Thermal Fuse

If the oven gets too hot, the thermal fuse trips to shut off power to the oven. If the thermal fuse has blown, the oven will not heat. However, this is not a common occurrence. To determine if the thermal fuse is at fault, use a multimeter to test the fuse for continuity. If the thermal fuse does not have continuity, replace it. The thermal fuse cannot be reset—if the fuse has blown, it must be replaced.

Part Testing
Parts
Thermal Fuse for your FrigidaireRange/Stove/Oven
Thermal Fuse - Part # 499302 Mfg Part # 318004900

High temperature cut-out fuse *Push red button to reset.

Add to Cart
Cause 5Loose or Burnt Wire Connection

One of the wires that supply power to the oven element or igniter might be burnt out. These wires commonly burn out near the heat source. To determine if a wire has burned out, inspect the wires leading to the element or igniter. If a wire is burned out, it will often be visibly burnt.

Cause 6Relay Board

Some ovens are equipped with a relay board. The relay board has several relays which control the electrical current to the heating element. If one or more of the relays on the relay board has failed, the oven won’t heat. If the relay board is defective, replace it.

Parts
Relay Board for your FrigidaireRange/Stove/Oven
Relay Board - Part # 499738 Mfg Part # 318022001
Add to Cart
Cause 7Relay Board

Some ovens are equipped with a relay board. The relay board has several relays which control the electrical current to the heating element. If one or more of the relays on the relay board has failed, the oven won’t heat. If the relay board is defective, replace it.

Parts
Relay Board for your FrigidaireRange/Stove/Oven
Relay Board - Part # 499739 Mfg Part # 318022002

Oven relay board with transformer. This relay board has several relays that control the power to the heating element. If one or more of the relays have failed, the oven will not heat. The relay board is often incorrectly diagnosed—be sure to test more commonly defective parts before replacing it.

Add to Cart
Cause 8Oven Control Board

The oven control board has relays that send voltage to the bake and broil circuits according to the user settings and sensor input. If the control board is defective, it may not send voltage to the heating components. However, this is rarely the case. Before replacing the control board, first test all of the heating components. If you determine that all of the heating components are working properly, replace the oven control board. Since it’s not easy to test the oven control board, you will have to replace the control board if you suspect it is defective.

Parts
Oven Control Board for your FrigidaireRange/Stove/Oven
Oven Control Board - Part # 499450 Mfg Part # 318010501

Oven Control Board. NOTE: This part is often misdiagnosed due to a faulty Relay Control Board within the appliance.

Add to Cart