• 1-800-269-2609
  • En Español
  • Available 7 days a week

Maytag Washer Stops Mid Cycle

MHWE300VW12

The part(s) or condition(s) listed below for the symptom Washer stops mid cycle are ordered from most likely to least likely to occur. Check or test each item, starting with the items at the top of the page.

Most Frequent Causes for Washer stops mid cycle

Cause 1Water Inlet Valve

During the rinse cycle, the water inlet valve opens to allow water to enter the wash tub. If the water inlet valve fails, the washer will continue waiting for the water to enter the washer, causing it to stop mid-cycle. To determine if the water inlet valve is defective, use a multimeter to test it for continuity. If the water inlet valve does not have continuity, replace it.

Part Testing
Parts
Water Inlet Valve for your MaytagWashing Machine
Water Inlet Valve - Part # 1194900 Mfg Part # WP8182862

Washing machine water inlet valve. A long or slow fill cycle is often due to a restricted water valve. The valve should never be disassembled and cleaned, only replaced.

Add to Cart
Install Help
Cause 2Main Control Board

The main control board might be defective. However, the main control board is rarely at fault for this symptom. Before replacing the main control board, first check all of the more commonly defective parts.

Parts
Main Control Board for your MaytagWashing Machine
Main Control Board - Part # 4443591 Mfg Part # WPW10271604
Add to Cart