• 1-800-269-2609
  • En Español
  • Available 7 days a week

Maytag Washer Stops Mid Cycle

MAH4000AWW

The part(s) or condition(s) listed below for the symptom Washer stops mid cycle are ordered from most likely to least likely to occur. Check or test each item, starting with the items at the top of the page.

Most Frequent Causes for Washer stops mid cycle

Cause 1Water Inlet Valve

During the rinse cycle, the water inlet valve opens to allow water to enter the wash tub. If the water inlet valve fails, the washer will continue waiting for the water to enter the washer, causing it to stop mid-cycle. To determine if the water inlet valve is defective, use a multimeter to test it for continuity. If the water inlet valve does not have continuity, replace it.

Part Testing
Parts
Water Inlet Valve for your MaytagWashing Machine
Water Inlet Valve - Part # 455469 Mfg Part # WP22002795

Water inlet valve assembly

Add to Cart
Cause 2Main Control Board

The main control board might be defective. However, the main control board is rarely at fault for this symptom. Before replacing the main control board, first check all of the more commonly defective parts.

Parts
Main Control Board for your MaytagWashing Machine
Main Control Board - Part # 775784 Mfg Part # WP22002989

Machine control board. *Burned resistor on board indicates another problem within the machine.

Add to Cart
Cause 3Timer

The timer might be defective. The timer is frequently misdiagnosed—before replacing the timer, first check all of the more commonly defective parts. To determine if the timer is defective, consult your washer’s wiring diagram and use a multimeter to test the timer for continuity.

Parts
Timer for your MaytagWashing Machine
Timer - Part # 455526 Mfg Part # WP22002867

Timer. NOTE: Timers are often misdiagnosed. Visit our Repair Help section of the website for additional repair information.

Add to Cart
Cause 4Timer

The timer might be defective. The timer is frequently misdiagnosed—before replacing the timer, first check all of the more commonly defective parts. To determine if the timer is defective, consult your washer’s wiring diagram and use a multimeter to test the timer for continuity.

Parts
Timer for your MaytagWashing Machine
Add to Cart