Bullet piercing valve kit - 1/4", 5/16", 3/8"
3 in 1 Start kit, for compressor sizes 1/4 through 1/3 HP. Combination relay, capacitor, and overload device; totally pre-wired. Will replace all 3 electrical components on capillary refrigeration systems.
Digital Multimeter is an economical solution to your everyday electrical & temperature measurement needs. 750 volts AC , 1000 Volts DC. Temperature: -4 F to 2498 F, Operating Temp: 32F to 74F (0 C to 23 C), Fuse Protection mA: 0.2A/ 250V, 9 volt battery & temp probe included.
Dryer vent testing kit is for 29" dryers with a top mounted lint screen. Use the plastic card to hang inside your dryer drum, then run the unit three times empty. If the card stays in place, the venting and dryer need to be cleaned out. Complete instructions are included.
3 in 1 Start kit. For compressors with horse power of 1/12 through 1/5.
Ignition System Tester
This part is used to test the spark on ignition coils. One of the first steps you should take when you are having ignition troubles is to test the ignition coil with this tool. This part can be used on all engines except the Vanguard 3 L/C gas engine.
Ignition Output Tester (all except capacitive discharge engines). Fires at 12kV.
Test leads (ins. alligator clips) low voltage 22in
Tachometer (Treysit Sirometer)
This part is used to determine the RPMs of your engine. It measures from 800 to 25,000 revolutions per minute and can work on any small engine.
DC Shunt (Electrical)
Non-contact A/C voltage detector. Test for voltage without touching any bare wires. This detector works by sensing voltage through the wire's insulation. Detector has an audible beeper and visible flashing light indicator.