Dryer heating element thermal cut-off (thermal fuse) 309 degrees and high limit thermostat 250 degrees, with wiring kit. If the dryer does not heat the thermal cut off may have blown and a new high limit thermostat is needed.
Washing machine agitator directional cogs. These parts are also referred to as "dog ears." 4 per package. If the upper section of the agitator isn't turning properly, then these cogs are likely worn and will require replacement.
Washer drive motor coupler. New style with metal sleeves for added strength. This version replaces all previous motor coupler styles and versions. For direct drive washing machines. Common symptom of failed coupler is washer will fill, not agitate or spin but will drain the water from the tub.
Lid lock latch assembly. The part might arrive in the locked position. Per the manufacturer install the lid lock & power up washing machine to reset lock to the open position.
Washing machine tub suspension rod kit,. Set of 4 rods, 4 suspension balls and 4 bushings. The suspension rods help to dampen the movement of the washer tub. If one or more of the suspension rods are broken, the washer will vibrate or shake.
Washing machine drain pump. The pump mounts directly to the motor with two clips. If the washer does not drain then the pump could be locked up or a small object may be clogging it. A small leak in front of the washer could be caused by a defective pump.
Washing machine agitator repair kit with a medium length cam (there are other kits available for different models). This kit should be used when the top part of the agitator is not moving properly but the bottom part is.
Washing machine clutch assembly with hardware. *Blue spring for regular, large, extra and super capacity washers, black for compact models. A worn clutch often causes a slower spin speed which leaves the clothes soaked after the cycle.
Washing machine suspension spring. If the suspension spring is broken, the washer will be off balance.
Door strike/catch for front-loading washing machine. The washer door must be latched shut in order for the washer to start. If the door strike is damaged or defective, the washer door won't latch, and the washer will not be able to start.
Includes latch assembly, one white and one gray lid lock bezel. Lid must be closed for washer to fill, wash, drain, or spin. If the machine is not advancing into the cycle or is displaying a lid lock fault this may be the cause of the issue.
Direct drive washer lid switch assembly, If the washing machine does not spin the lid switch may have failed.
Drive Clutch Kit. This kit has 6 parts; a spring, housing, cam ring, basket drive gear, pulley, and nut. The pulley is driven by the drive belt and the splutch works with the mode shift actuator to operate the washplate and spin the inner basket. A worn splutch can cause spin or washplate problems.
Washing machine water inlet valve kit with bracket. A long or slow fill cycle is often due to a restricted water valve. The valve should never be disassembled and cleaned, only replaced.