Kenmore Washing Machine Parts

Dryer tri-ring retainer for drum support rollers.

OEM Part - Manufacturer #WPW10512946

Washing machine agitator repair kit with a medium length cam (there are other kits available for different models). This kit should be used when the top part of the agitator is not moving properly but the bottom part is.

OEM Part - Manufacturer #285811

Consider replacing the bolt and getting a spare set of dog ears. The bolt can get corroded and the dog ears wear out over time.

Washing machine drain pump. If the washer does not drain then the drain pump may be clogged, damaged, or defective.

OEM Part - Manufacturer #4681EA2001T

If your washer smells we recommend cleaning it with Affresh once a month.

Washing machine drain pump. The pump mounts directly to the motor with two clips. If the washer does not drain then the pump could be locked up or a small object may be clogging it. A small leak in front of the washer could be caused by a defective pump.

OEM Part - Manufacturer #WP3363394

Consider replacing the motor coupling while you have the washing machines cabinet off.

Washing machine agitator directional cogs. These parts are also referred to as "dog ears." 4 per package. If the upper section of the agitator isn't turning properly, then these cogs are likely worn and will require replacement.

OEM Part - Manufacturer #80040

If your washer has an unpleasant odor than we recommend using Affresh washing machine cleaner.

Affresh™ Washing machine cleaner. This cleaner removes and prevents odor-causing residue in all brands of washers. To use, add one tablet to washer with no clothes and select hot water.

- Septic safe
- More effective than bleach.
- Three tablets per package.

OEM Part - Manufacturer #W10135699

Affresh® Dishwasher Cleaner is specially formulated to help remove limescale and mineral build-up.

Washing machine lid switch assembly with wire harness. The lid switch ensures that the washer door is closed while the washer is spinning. If the lid switch is broken, the washer will not spin. If the washer won't spin but will still agitate, the lid switch is likely defective.

OEM Part - Manufacturer #3949247V

If your washing machine has a moldy or musty odor, we recommend cleaning it with Affresh washing machine cleaner.

Washer lid lock latch kit. Includes the lock latch assembly, one white and one gray lid lock bezel & instructions. Lid must be closed for washer to fill, wash, drain, or spin. If the washing machine is not advancing into the cycle or is displaying a lid lock fault this may be the cause of the issue.

OEM Part - Manufacturer #W10404050

Washing machine clutch assembly with hardware. *Blue spring for large capacity washers, black for compacts. A worn clutch often causes a slower spin speed which leaves the clothes soaked after the cycle.

OEM Part - Manufacturer #285785

Washing machine suspension spring. If the suspension spring is broken, the washer will be off balance.

OEM Part - Manufacturer #WP63907

Washing machine water inlet valve kit with bracket. A long or slow fill cycle is often due to a restricted water valve. The valve should never be disassembled and cleaned, only replaced.

OEM Part - Manufacturer #285805

Spanner nut wrench for many Whirlpool, Kenmore, General Electric & Maytag inner tub lock nuts

Aftermarket (Non-OEM) Part - Manufacturer #TB123A

Washing machine mode shift actuator. The actuator serves several functions. It has a synchronous motor that shifts the splutch cam ring and monitors the position of the splutch. It also houses a transmission speed/position optical sensor.

OEM Part - Manufacturer #WPW10006355

Consider replacing the washer drive belt while you have the washer apart.

25 watt light-bulb for various appliances, 120 volts, small base screw-in.

OEM Part - Manufacturer #WPA3073101

Washer hot water inlet valve. Standard hose fitting inlet, 1 water outlet. The water inlet valve opens to allow water to enter the washing machine. If the water inlet valve is defective, the wash may fill slowly or not fill at all.

OEM Part - Manufacturer #5220FR2006H

Consider replacing the old fill hose when installing a new valve.

Direct drive washer lid switch assembly, If the washing machine does not spin the lid switch may have failed.

OEM Part - Manufacturer #WP8318084

Door lock and switch assembly

OEM Part - Manufacturer #131763255

Make sure the door strike is not damaged.

Screw

OEM Part - Manufacturer #WP308685

Washing machine tub counterbalance spring. This spring offsets the weight of the motor on the front of the washer. If broke, the tub will lean forward and the tub will be off balance during the spin cycle.

OEM Part - Manufacturer #WPW10250667

Washing machine tub suspension rod kit,. Set of 4 rods, 4 suspension balls and 4 bushings. The suspension rods help to dampen the movement of the washer tub. If one or more of the suspension rods are broken, the washer will vibrate or shake.

OEM Part - Manufacturer #W10780048

Washing machine drain pump. *Coin trap only available with pump assembly. If the washer does not drain the pump could be locked up or a small object may be clogging it. Also a small leak in front of the washer could be caused by a defective pump.

OEM Part - Manufacturer #WPW10730972

If your washer smells we recommend cleaning it with Affresh once a month.

Washer cold water inlet valve assembly. Three solenoids

OEM Part - Manufacturer #5220FR2075L

Washing machine door boot. If the washer is leaking, the door boot may have a tear in it. Overloading the washer is the most common cause for a torn door boot.

OEM Part - Manufacturer #WP8182119

Check out the Related Items for boot seal clamps and a good washing machine cleaner.

Washing machine lid switch assembly with wire harness. If the washer does not spin, but will agitate then the lid switch is likely defective.

OEM Part - Manufacturer #WP3949238

Light bulb, 10 watt.

OEM Part - Manufacturer #WP22002263

Washer main drive belt. This belt is located under the washing machine and is used to drive the splutch pulley. It goes around the motor & splutch pulleys. Worn or broken drive belt can cause spin or washplate problems.

OEM Part - Manufacturer #WPW10006384

Tub centering spring

OEM Part - Manufacturer #W10400895

Outer tub and drive shaft repair kit. If the washer is noisy during the spin cycle or is leaking from the bottom of the tub this kit may be needed. Bearing and seal tool required to install this kit. See Related Items below.

OEM Part - Manufacturer #W10435302

The suggested tool is required to install this kit according to the manufacturer.

Adjustable leveling leg for washing machine. This leveling leg has a rubber foot. If the leveling leg is not adjusted properly, the washer will be off-balance and will vibrate or shake during operation.

OEM Part - Manufacturer #WPW10001130

Washer agitator bolt with rubber gasket and thread sealant. Head is 7/16 inches in diameter.

OEM Part - Manufacturer #WP358237

Washing machine drain pump assembly. If the washer does not drain the pump may be clogged, damaged, or defective.

OEM Part - Manufacturer #280187

If your washer smells we recommend cleaning it with Affresh once a month.

Washing machine tub seal. If the washing machine is leaking water from above the transmission, this seal is likely damaged or worn out.

OEM Part - Manufacturer #4036ER2004A

Washing machine tub seal. Located between the front outer tub and rear outer tub. If the washing machine is leaking water from above the transmission, this seal is likely damaged or worn out.

OEM Part - Manufacturer #4036ER4001B

The tub seal and bearing should be replaced at the same time.

Washing machine drain hose with bellows. This drain hose makes a connection from the washer tub to the drain pump.

OEM Part - Manufacturer #4738ER1002A

If your washing machine has a moldy or musty odor, we recommend cleaning it with Affresh washing machine cleaner.

Shock absorber. This shock absorber prevents the washer from vibrating by absorbing the movements of the washer tub.

OEM Part - Manufacturer #W10822553

Door strike/catch for front-loading washing machine. The washer door must be latched shut in order for the washer to start. If the door strike is damaged or defective, the washer door won't latch, and the washer will not be able to start.

OEM Part - Manufacturer #131763310

If your washing machine has a moldy or musty odor, we recommend cleaning it with Affresh washing machine cleaner.

Tub bearing. This parts is very difficult to install. The manufacturer recommends replacing the complete rear tub and bearing assembly.

OEM Part - Manufacturer #4280FR4048L

Washer tub suspension rod kit. Suspension rod supports included. The suspension rods help to dampen the movement of the washer tub. If one or more of the suspension rods are broken, the washer will vibrate or shake.

OEM Part - Manufacturer #W10820048

Washing machine shock absorber kit. The shock absorbers dampen the vibration of the washer tub. If one or more of the shock absorbers are worn out, the washer will vibrate or shake.

OEM Part - Manufacturer #5304485917

Washer tub bearing, rear. This part is very difficult to install. The manufacturer recommends replacing the complete rear tub and bearing assembly.

OEM Part - Manufacturer #4280FR4048E

White touch-up paint

OEM Part - Manufacturer #72017

Washer door lock latch assembly. The door lock secures the washer door shut during operation. Once the washing machine door is closed, the washer can begin operating. If the door lock is defective, the washer door will not latch properly.

OEM Part - Manufacturer #WP8182634

If your washing machine has a moldy or musty odor, we recommend cleaning it with Affresh washing machine cleaner.

Drive Splutch Kit. This kit has 6 parts; a spring, housing, cam ring, basket drive gear, pulley, and nut. The pulley is driven by the drive belt and the splutch works with the mode shift actuator to operate the washplate and spin the inner basket. A worn splutch can cause spin or washplate problems.

OEM Part - Manufacturer #W10721967

The drive belt wears out over time. You may want to replace the drive belt while the washer is apart.

Filter screens for washer water inlet valve. Includes two filter screens.

OEM Part - Manufacturer #AGM73269501

If your washing machine has a moldy or musty odor, we recommend cleaning it with Affresh washing machine cleaner.

White washer lid strike assembly. The strike is what the lid lock hooks onto to lock the washing machine lid. If the washing machine is not advancing into the cycle or is displaying a lid lock fault this may be the cause of the issue.

OEM Part - Manufacturer #WPW10240513

Faucet adapter for portable dishwasher or washer

OEM Part - Manufacturer #WPW10254672

Washing machine rotor position sensor assembly. This part is also called a hall sensor or motor sensor. When this part fails the control may display an LE error code.

OEM Part - Manufacturer #6501KW2002A

Washing machine agitator repair kit. Includes agitator cam and 4 directional cogs (also called dog ears). If the upper section of the agitator isn't turning properly, then the agitator cam and dog ears are likely worn-out and require replacement.

OEM Part - Manufacturer #285751

To purchase the dog ears separately, order item 3109.