40 Watt frosted appliance light bulb.
Oven bake element. The terminals are male quarter inch spade connectors. The wires push onto the heating elements connectors. If the oven does not bake then the element could have burned out.
Chrome drip bowl (also called a drip pan) for 8 inch burner on an electric range. The drip pan sits underneath the heating element to collect drips or spills around the burner.
Oven igniter kit. Can replace igniters for either bake or broil burners. Replaces shorter and longer igniters in many instances. Amperage range is 3.3 - 3.6. If the igniter glows for more than 90 seconds without igniting the gas flame, this indicates that the igniter is too weak to open the valve.
Oven ignitor, this item is also referred to as a glow bar. The igniter is mounted vertically on the burner tube. If the oven does not heat check if the igniter is glowing, if so then there is a good chance the igniter is weak and will need repalcement.
25 watt light-bulb for various appliances, 120 volts, small base screw-in. Bulb has been updated and you may need the recommended socket to install this light bulb. Also bulb is no longer blue tint per factory.
Chrome drip bowl (also called a drip pan) for 6 inch burner on an electric range. The drip pan sits underneath the heating element to collect drips or spills around the burner.
White silicone adhesive caulk. Forms a heat resistant bond. Often used for gaskets, seals and burner grate feet.
Stove top receptacle kit for electric stove surface elements. If the heating element operates intermittently then this terminal block or the elements terminals are likely corroded and both may need to be replaced.
White touch-up paint. .6 oz.
Range leveling leg, black plastic. This leg may be shorter than the original but is the factory replacement. Longer leg is not available.
Oven bake element with push-on terminal ends. It is not unusual for a bake element to short out and arc in one spot. If this occurs, disconnect the power to the stove until the element has been replaced.
8-inch diameter plug-in surface heating element with looped terminal ends. 5 turn. 2600 Watt. If your surface element won't heat, either the surface element or the surface element switch may be defective. To determine if the surface element is defective, use a multimeter to test it for continuity.
Front glide for oven drawer. Requires (2) one for each side. For the rear glides see related parts below.