Shop Crosley Range/Stove/Oven Parts

40 Watt frosted appliance light bulb.

Chrome drip bowl (also called a drip pan) for 8 inch burner on an electric range. The drip pan sits underneath the heating element to collect drips or spills around the burner.

Oven bake element. The terminals are male quarter inch spade connectors. The wires push onto the heating elements connectors. If the oven does not bake then the element could have burned out.

Chrome drip bowl (also called a drip pan) for 8-inch burner. The drip pan sits underneath the heating element to collect drips or spills around the burner.

Chrome drip bowl for 6-inch electric coil burner. This drip bowl sits underneath the burner to catch drips or spills.

Chrome drip bowl (also called a drip pan) for 6 inch burner on an electric range. The drip pan sits underneath the heating element to collect drips or spills around the burner.

Stove top surface element terminal block kit with interchangeable mounting brackets. The kit also includes ceramic wire nuts, heat shrink protective tubing, and wires. If the element works intermittently then the receptacle may be making poor contact with the element and needs replacement.

Screw

Oven ignitor, this item is also referred to as a glow bar. The igniter is mounted vertically on the burner tube. If the oven does not heat check if the igniter is glowing, if so then there is a good chance the igniter is weak and will need repalcement.

Oven bake element with push-on terminal ends. It is not unusual for a bake element to short out and arc in one spot. If this occurs, disconnect the power to the stove until the element has been replaced.

White silicone adhesive caulk

Oven igniter kit. Can replace igniters for either bake or broil burners. Replaces shorter and longer igniters in many instances. Amperage range is 3.3 - 3.6. If the igniter glows for more than 90 seconds without igniting the gas flame, this indicates that the igniter is too weak to open the valve.

Torx screw, 7-18 x 3/4"

Surface element control switch for the large surface element. If the surface element is not heating the element can be tested to determine if it is defective. If not, the switch is likely causing the problem.

Range leveling leg, black plastic.