40 Watt frosted appliance light bulb.
Oven igniter assembly. Short ceramic style igniter with mounting bracket and wire nuts for installation. Amperage range is 3.3 to 3.6. *Connector may need to be cut off and wires spliced to range wiring with porcelain wire nuts.
Stove top surface element terminal block kit with interchangeable mounting brackets. The kit also includes ceramic wire nuts, heat shrink protective tubing, and wires. If the element works intermittently then the receptacle may be making poor contact with the element and needs replacement.
8-inch diameter plug-in surface heating element with looped terminal ends. 5 turn. 2600 Watt. If your surface element won't heat, either the surface element or the surface element switch may be defective. To determine if the surface element is defective, use a multimeter to test it for continuity.
Light bulb 40 watt 120 volt medium standard base. Used in many refrigerators and ranges.
6 inch burner pan
Refrigerator or freezer temperature sensor (also called a thermistor). The thermistor monitors the refrigerator, freezer, and evaporator temperature and sends the temperature reading to the control board.
Oven bake or broil igniter, 2.5 to 3.0 Amp. The igniter draws electrical current through the oven safety valve to open it. If the igniter glows for more than 90 seconds without igniting the gas flame, this indicates that the igniter is too weak to open the valve. (NOTE: This part is very fragile.)
Oven bake heating element. Push-on wire terminals. Includes feet for sitting on bottom of oven floor, and mounting plate for attaching to back wall of oven. Often, if the heating element has burned out, it will be visibly damaged. Inspect the heating element for holes or blisters.
Push to start switch
Oven bake heating element with screw-on terminals. The element is 18-1/4 inches wide, 14-1/2 inches deep to mounting flange. Terminal ends extend 2-1/2 inches past flange. 2,300 watts at 220 volts. If the oven does not heat the bake element may have burned out.
Oven bake element. It is not unusual for a bake element to short out and arc in one spot. If this occurs, disconnect the power to the stove until the element has been replaced.