Oven bake element. The terminals are male quarter inch spade connectors. The wires push onto the heating elements connectors. If the oven does not bake then the element could have burned out.
Chrome drip bowl (also called a drip pan) for 8-inch burner. The drip pan sits underneath the heating element to collect drips or spills around the burner.
Chrome drip bowl for 6-inch electric coil burner. This drip bowl sits underneath the burner to catch drips or spills.
Oven igniter assembly. Short ceramic style igniter with mounting bracket and wire nuts for installation. Overall length is 3.72", amperage range 3.2 to 3.6. The igniter is the most commonly defective part for a gas oven not heating correctly or at all.
Dryer rear drum bearing kit. The holes in the metal plate are not threaded. Use the self tapping screws in the kit to thread the plate. If the dryer is noisy then the rear bearing could be worn and require replacement.
Stove top surface element terminal block kit with interchangeable mounting brackets. The kit also includes ceramic wire nuts, heat shrink protective tubing, and wires. If the element works intermittently then the receptacle may be making poor contact with the element and needs replacement.
Oven igniter with wire harness
Appliance light bulb, clear 120 Volt 40 Watt Regular Base
Surface element control switch for the large surface element
Oven temperature sensor
Stove top coil surface heating element, 8 inch. If the element does not heat either it or the control switch is defective. The coil can be tested to determine if it is at fault.
Front glide for oven drawer. Requires (2) one for each side. For the rear glides see related parts below.
Oven temperature sensor *May require cutting and splicing wire connector
Range/stove surface element (6-inch). If the surface element won't heat, either the surface element or the surface element switch may be defective. To determine if the surface element is defective, use a multimeter to test it for continuity.
Rear glide for oven lower storage drawer.