Oven igniter assembly. Short ceramic style igniter with mounting bracket and wire nuts for installation. Amperage range is 3.3 to 3.6. *Connector may need to be cut off and wires spliced to range wiring with porcelain wire nuts.
Oven bake or broil igniter, 2.5 to 3.0 Amp. The igniter draws electrical current through the oven safety valve to open it. If the igniter glows for more than 90 seconds without igniting the gas flame, this indicates that the igniter is too weak to open the valve. (NOTE: This part is very fragile.)
Burner drip bowl (also called a drip pan) for 6-inch burner. The drip pan sits underneath the heating element to collect drips or spills around the burner.
Burner drip bowl (or drip pan) for 8-inch burner. The drip pan sits underneath the heating element to collect drips or spills around the burner.
Light bulb 40watt 120volt meduim standard base. Used in many refrigerators and ranges.
Range/stove burner grate, black. Approximatey 9" X 9"
Secondary microwave door switch. Switch contacts are normally open
Washer or dryer selector switch knob with clip in white.
Oven bake element. The terminals are male quarter inch spade connectors. The wires push onto the heating elements connectors. If the oven does not bake then the element could have burned out.
Appliance light bulbs (2 pack).
End cap, oven door handle, black. Be aware that not all range handle endcaps require locating pins. If your model does not have locating pins, you may discard them.
Range/stove terminal block (receptacle) kit. The surface element plugs onto this receptacle. If the receptacle's contacts are burned out, the surface element will not get power.
Door switch, monitor (normally closed)
Stove top coil surface heating element, 8 inch. If the element does not heat either it or the control switch is defective. The coil can be tested to determine if it is at fault.