Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.
Dryer drum belt, length 88.75" x width 1/4". If the drum does not turn, but you can hear the motor running then there is a good chance the belt has broken.
Door strike/catch for front-loading washing machine. The washer door must be latched shut in order for the washer to start. If the door strike is damaged or defective, the washer door won't latch, and the washer will not be able to start.
Dryer rear drum bearing kit. The holes in the metal plate are not threaded. Use the self tapping screws in the kit to thread the plate. If the dryer is noisy then the rear bearing could be worn and require replacement.
White touch-up paint. .6 oz.
Dryer door catch kit. If the dryer does not latch properly then either the strike or catch is likely damaged and will need to be replaced.
Door lock & switch assembly
Dryer lint trap. Proper air flow is critical to dryer operation so the filter should be cleaned before every load. Replace the filter if it has any tears or rips in it.
Dryer gas valve solenoid coil kit. The kit includes both 2 and 3 wire coils. If the dryer does not heat or heats intermittently the gas valve coils may be defective.
Washing machine drain pump. On some models you will need to configure the replacement pump to match the old pumps outlet port direction and reuse the old mounting bracket. If the washer does not drain then the drain pump may be clogged, damaged, or defective.
Washer drive belt. If this belt is broken, the washer will not spin or agitate.
Spray paint, white, 12 ounces
Dryer thermal limiter (or thermal fuse). May be located on the blower housing or element. If the dryer overheats, the thermal fuse blows to cut off power to the dryer. If the thermal fuse has blown, the dryer won't start. The thermal fuse cannot be reset--if the fuse has blown, it must be replaced
Washer door boot gasket. The door boot can tear if the washer is overloaded.